Electronics Forum | Thu Jan 13 13:16:40 EST 2000 | Dave F
Tony: You have choices: * Hi Temperature Tape: Go with Wolfgang ... too tough to control. * Selective Soldering Pallets: Some like 'em some don't. A lot of your success depends on the pallet fabricator. * Screenable Temporary Solder Mask: Wol
Electronics Forum | Thu Nov 29 01:37:30 EST 2018 | cannizzaro
I think silicone mask is ok, This is so that after soldering, you can use these holes to fit other components later. This peelable layer is needed, unless you want to solder each component manually--From ALLPCB
Electronics Forum | Thu Aug 19 17:50:49 EDT 1999 | Stu Leech
| | | | | | We have developed a new process for removing moisture from surface mount devices. We have one site where PCB laminate drying has been reduced to 1.5 hours. A standard oven took 4 hours to do the job. I am looking for a firm who does large
Electronics Forum | Sat Aug 21 14:35:28 EDT 1999 | Stu Leech
| | | | | | | We have developed a new process for removing moisture from surface mount devices. We have one site where PCB laminate drying has been reduced to 1.5 hours. A standard oven took 4 hours to do the job. I am looking for a firm who does lar
Electronics Forum | Fri Apr 07 17:17:55 EDT 2000 | Dave F
Ashok: You should select and use low residue tapes. But ya know, ya go out and research a great tape and if yer not careful, the buyer will second source ya and (surprise) ya got residues again. We have found that Lemme say this about Katon tape
Electronics Forum | Thu Sep 30 15:06:05 EDT 1999 | Dave F
| Guys & Gals, | | I am at present instigating a formal method of recording and tracking any "process" trials that we may wish to run, such as a new paste, different packaged device etc; | | I started with a simple form.....too simple, but now I th
Electronics Forum | Fri Mar 04 17:19:31 EST 2005 | davef
Mrduckmann2000: Why do you want to do this? * Removing a non-washable / peelable temporary solder resist [TSR] is going become very tedious, because they do not release well from small / tight / isolated features. * Clay from washable resists will
Electronics Forum | Sun Aug 15 11:02:37 EDT 1999 | Jeff Ferry
| Ladies and Gentlemen, | | As a newly appointed DFM/CE "guru" here, one of my responsibilities has become repair (of course). As I have some knowledge of BGA repair/rework using semi-automated equipment, it naturally follows I would hav tremendous