Industry News | 2015-09-22 11:52:54.0
PennEngineering® has been awarded U.S. Patent No. 9,113,567 for a unique three-piece heat sink mounting system designed to securely attach heat sinks to printed circuit boards while providing firm and constant contact to the chip component for optimized heat dissipation. The inventor of this dynamic mounting system is Robert F. Stotz, Jr.
Industry News | 2019-02-26 09:16:08.0
New PEM® SMTSK™ unthreaded standoffs from PennEngineering® permanently surface mount on printed circuit boards to enable quick attachment and removal of stacked components without requiring screws or tools. Their unique barrel design allows for a stacked board or panel to be slipped easily into place and then detached by simply sliding the component sideways and lifting it off. These standoffs will effectively serve to attach and
Industry News | 2016-01-07 09:07:41.0
The expanding line of PEM® ReelFast® surface mount fasteners from PennEngineering® offers a variety of reliable attachment solutions for printed circuit board applications. Depending on type, the fasteners can be specified to mount, stack, or space boards; attach components to boards; create right-angle attachment points on boards; or enable repeated access without requiring loose screws.
Electronics Forum | Fri Aug 25 07:53:12 EDT 2006 | Hussman
Board House, One last question. Could the above changes make the board more ridid? My concern is we insert Pem nuts via a press. Nothing has changed in this process except the board house. Now when ever we insert these Pem nuts the board cracks.
Electronics Forum | Fri Mar 27 09:37:15 EDT 2009 | cyber_wolf
There are pem nuts on the back side of the teddy bear face. One of them probably fell off and either shorted your main board or it is lodged in the belt and pulley that drives the advancing wheels. Take the front part of the feeder off that has the t
Electronics Forum | Sun Nov 01 21:01:26 EST 2009 | isd_jwendell
I'm at 6800 ft. The only issue I had was related to a PEM nut that was not packaged properly. There was a piece of K@pton tape that was not centered on the part and the tape would stick to the carrier. The vacuum on my machine would not allow me to
Electronics Forum | Wed Oct 30 15:50:22 EDT 2013 | joeherz
Vince, We see the same disks on some parts incoming. SMT PEM nuts in tape and reel are very common. We get the parts from PENN Engineering. One of them is SMTSO-M3-4ET. PENN Engineering may be able to steer you in the right direction on who their
Electronics Forum | Sat Feb 12 08:13:48 EST 2005 | pemnut
I have seen BEC holes drilled wrong also. On a couple of products We run, We insert a Pem Nut. The insertion hole is too large for BEC to read. So We have the board house drill a small hole for each array, circuit. If these smaller holes are drilled
