Electronics Forum | Mon Jul 20 04:19:01 EDT 1998 | Michael Jeremias
Who knows something about the reliability of plasti PEMS and its enhancemant by application of conformal coating (Parylene, metal, SiO2, SiNxOx, etc.) ?
Electronics Forum | Thu Nov 17 13:26:42 EST 2005 | chunks
yeah, i tried um once and they worked great. gwad dam management wouldnt buy em though.
Electronics Forum | Thu Nov 17 15:40:03 EST 2005 | Kornholio
I purchased them too but it was a conspiracy that they didn't work because an operator told management and he took all the credit.
Electronics Forum | Thu Nov 17 17:35:06 EST 2005 | russ
If you only need to keep the threads clear you can use nylon screws and then remove them after they get cool.
Electronics Forum | Fri Feb 24 15:12:20 EST 2006 | Chunks
I like Ticky Ticky Tembo No Sarimbo Hari Kari Bushkie Perry Pem Do Hai, who just posted here lately. Get right to the point. I don't think your "cool" name was stressing people out - more like it "dehumanizing" them! (I was accused of doing the sa
Electronics Forum | Fri Mar 27 09:37:15 EDT 2009 | cyber_wolf
There are pem nuts on the back side of the teddy bear face. One of them probably fell off and either shorted your main board or it is lodged in the belt and pulley that drives the advancing wheels. Take the front part of the feeder off that has the t
Electronics Forum | Sun Nov 01 21:01:26 EST 2009 | isd_jwendell
I'm at 6800 ft. The only issue I had was related to a PEM nut that was not packaged properly. There was a piece of K@pton tape that was not centered on the part and the tape would stick to the carrier. The vacuum on my machine would not allow me to
Electronics Forum | Fri Sep 02 16:22:37 EDT 2011 | ttaubert
Are there SMT mechanical components like that could be used for orientating PCB-level optics on the board and do not require holes in the board? Their final position would solely depend on the reflow. A height of 1/8" would be sufficient. I was con
Electronics Forum | Wed Oct 30 15:50:22 EDT 2013 | joeherz
Vince, We see the same disks on some parts incoming. SMT PEM nuts in tape and reel are very common. We get the parts from PENN Engineering. One of them is SMTSO-M3-4ET. PENN Engineering may be able to steer you in the right direction on who their
Electronics Forum | Sat Feb 12 08:13:48 EST 2005 | pemnut
I have seen BEC holes drilled wrong also. On a couple of products We run, We insert a Pem Nut. The insertion hole is too large for BEC to read. So We have the board house drill a small hole for each array, circuit. If these smaller holes are drilled
