Electronics Forum | Mon Feb 23 20:27:31 EST 2004 | greg york
Is this a white residue on the joint and surrounding area's, if so the only thing I can remove it with after cleaning is an Isopar(Isoparrafinic hydrocarbon), my guess looking at other pastes where I have seen this is it is a type of wax used in form
Electronics Forum | Mon Feb 23 20:27:34 EST 2004 | greg york
Is this a white residue on the joint and surrounding area's, if so the only thing I can remove it with after cleaning is an Isopar(Isoparrafinic hydrocarbon), my guess looking at other pastes where I have seen this is it is a type of wax used in form
Electronics Forum | Mon Jul 26 16:31:02 EDT 2004 | Sue PH
We use Kester 186 flux and the STU people would sometimes find white residue after cleaning with Isopropyl at the solder station. We have Lenium (Petroferm)in our vapor degreasers, and now they use Lenium at their stations as well as final clean, an
Electronics Forum | Tue Mar 15 13:24:44 EST 2005 | pjc
There is equipment available to clean NC residues off low standoff devices, well below 0.8mm (0.031"), from Speedline Technologies- Electrovert and Accel. See this paper under Accel: "High Reliability Underfill Performance through Proper Flip-Chip D
Electronics Forum | Mon Dec 18 13:00:47 EST 2006 | grantp
Hi, We have a white residue, which is visible, and we would like to have the produce clean as it's a PCI card, so users see the PCB. I am wondering if we need to install a cleaning stage to the line for these kinds of products. Can anyone give som
Electronics Forum | Thu May 24 14:44:42 EDT 2007 | colormaker
We use a washer soluable solder flux for our solder wave. We then wash the boards in a dishwasher. We have done it this way for years without problems. We just got a new dishwasher and now we get residue on the solder (white marks) Anyone know of wh
Electronics Forum | Mon Aug 24 03:59:26 EDT 2009 | hurr
Hallo Joanne, I had employed by producer of Ecofrec 303. We make many tests of corrosion and conductive test in our company. All results of this tests was OK . Vast majority correspond mil standarts. When I ask my labor assistent in BRY, white residu
Electronics Forum | Fri Aug 04 06:43:40 EDT 2017 | kubabel
Dear all, I´d like to ask You, if somebody faced similar situation like we are facing in our plant right now. We have wetting problems with some of our products. During SEM/EDX we found on non-wetted parts residues of Mineral oil - white - heavy. Do
Electronics Forum | Fri Nov 29 10:26:01 EST 2019 | marwan
flux my leave a white residues even after cleaning, when we want to select a flux for our Ersa Ecoslect we tryed a varity of fluxes (including the IF2005C) and we decide to use the Cobar 390-RX-HT because he gaved us the best results in soldering and
Electronics Forum | Fri May 11 15:43:41 EDT 2001 | davef
More information would be helpful. For instance: * Talk about the distribution of the problem, including a single lot or from various lots and over components and component types on the board * Tell us about the board (ie, thickness, type, solder ma