Electronics Forum | Mon Jul 21 08:34:44 EDT 2003 | Don Bell
Blow holes/ pin holes in solder joints are the result of multiple root causes. Suggested analysis might look like this; 1) What method of solder preservation is used on the bare board. (hasl,enig, osp, etc.) HASL can leave unwanted flux residues,
Electronics Forum | Sun Aug 15 11:02:37 EDT 1999 | Jeff Ferry
| Ladies and Gentlemen, | | As a newly appointed DFM/CE "guru" here, one of my responsibilities has become repair (of course). As I have some knowledge of BGA repair/rework using semi-automated equipment, it naturally follows I would hav tremendous
Electronics Forum | Fri Aug 13 07:11:12 EDT 1999 | Earl Moon
Ladies and Gentlemen, As a newly appointed DFM/CE "guru" here, one of my responsibilities has become repair (of course). As I have some knowledge of BGA repair/rework using semi-automated equipment, it naturally follows I would hav tremendous insigh
Electronics Forum | Mon Dec 17 11:55:08 EST 2007 | chef
I recently had the same problems, solder bridges on every thing I made, different customers boards, etc. I wave with no-clean flux. As I sorted out problems (pin holes, blow holes, splatter, etc.) I found a lot of variable factors. I changed flux,
Electronics Forum | Fri May 21 15:51:49 EDT 1999 | JohnW
Wendy.. I found that little nugget a good one from my connector suppliers..Oh we have a tool to put it in for u..only catch was the one I needed was �37K ! ! after falling off my seat I went for something like what I described blow..cost about �1K.
Electronics Forum | Tue Aug 17 10:48:16 EDT 1999 | Earl Moon
| | | | | | Ladies and Gentlemen, | | | | | | | | | | | | As a newly appointed DFM/CE "guru" here, one of my responsibilities has become repair (of course). As I have some knowledge of BGA repair/rework using semi-automated equipment, it naturally f
Electronics Forum | Fri Aug 13 10:00:45 EDT 1999 | Boca
| | Ladies and Gentlemen, | | | | As a newly appointed DFM/CE "guru" here, one of my responsibilities has become repair (of course). As I have some knowledge of BGA repair/rework using semi-automated equipment, it naturally follows I would hav treme
Electronics Forum | Fri Aug 13 13:25:09 EDT 1999 | ScottM
| | | | Ladies and Gentlemen, | | | | | | | | As a newly appointed DFM/CE "guru" here, one of my responsibilities has become repair (of course). As I have some knowledge of BGA repair/rework using semi-automated equipment, it naturally follows I wou
Electronics Forum | Fri Aug 13 13:00:08 EDT 1999 | Earl Moon
| | | Ladies and Gentlemen, | | | | | | As a newly appointed DFM/CE "guru" here, one of my responsibilities has become repair (of course). As I have some knowledge of BGA repair/rework using semi-automated equipment, it naturally follows I would hav
Electronics Forum | Tue Aug 17 10:32:19 EDT 1999 | Boca
| | | | Ladies and Gentlemen, | | | | | | | | As a newly appointed DFM/CE "guru" here, one of my responsibilities has become repair (of course). As I have some knowledge of BGA repair/rework using semi-automated equipment, it naturally follows I wou
.png)
