Electronics Forum | Fri Aug 13 09:51:25 EDT 1999 | Dave F
| Ladies and Gentlemen, | | As a newly appointed DFM/CE "guru" here, one of my responsibilities has become repair (of course). As I have some knowledge of BGA repair/rework using semi-automated equipment, it naturally follows I would hav tremendous
Electronics Forum | Fri Aug 13 08:14:38 EDT 1999 | Peter Barton
| Ladies and Gentlemen, | | As a newly appointed DFM/CE "guru" here, one of my responsibilities has become repair (of course). As I have some knowledge of BGA repair/rework using semi-automated equipment, it naturally follows I would hav tremendous
Electronics Forum | Tue Jan 19 20:47:35 EST 1999 | Steve Gregory
| Recently, someone in the SMTNET forum had installed a Wells-CTI Z-Lok socket and found that it was one row off from the board layout pads. Was the problem due to a layout error or was the datasheet incorrect? Dave ol' pal...dat wuz me...
Electronics Forum | Sat Aug 18 22:43:14 EDT 2012 | eadthem
we service all of our lightning spindles once a year, Take the spinldes off. loosen the screw by the nylon cap and slide the locking pin out. run the spindle shaft, the nylon cap and pin assembly , and spring thrue a ultrasonic cleaner with 99% is
Electronics Forum | Fri Jun 04 14:00:32 EDT 1999 | Arthur Burdick
Wendy, we at ASG make electric presses for press fit connectors, and have made fixtures for AMP Zpak connectors. give me a call i believe we can help. 561-848-6746 Arthur | Wendy.. | | I found that little nugget a good one from my connector supp
Electronics Forum | Fri Oct 04 11:34:42 EDT 2002 | Bob Willis
Some additional comments from a paper may be of interest. Baking Printed Circuit Boards - Why and How Baking printed boards prior to conventional and surface mount assembly should not be necessary. Often boards are baked for historical reasons; in
Electronics Forum | Fri Aug 13 11:21:15 EDT 1999 | Earl Moon
| | Ladies and Gentlemen, | | | | As a newly appointed DFM/CE "guru" here, one of my responsibilities has become repair (of course). As I have some knowledge of BGA repair/rework using semi-automated equipment, it naturally follows I would hav treme
.png)
