Electronics Forum | Fri May 23 00:16:31 EDT 2014 | edriansyah
Hello all. I need you advice and opinion on my problem with BGA drop off from the boards. Initial defect was ICT fail, but due to some accident, the board fell off, and the BGA just pop out. After some search, I end up to conclude it is a black pad
Electronics Forum | Wed Oct 31 04:37:15 EDT 2007 | aj
Hi, My oven has 5 zones each 12 inches in length , giving a total of 70 inches Heating Zone in total. I am working with a 6 layer PCB ,ENIG Finish. I am using Alpha OM338T no-clean Solder Paste. I am working to a cycle time of 4 to 4.5mins RTS p
Electronics Forum | Wed Dec 22 07:20:21 EST 2010 | piter
HI I used both of solder leveling HASL and ENIG, HASL I can recommended for biger pitch is cheaper solder leveling than ENIG but problem with that solder leveling is during the reflow process HASL isn't flat and during reflow process component move
Electronics Forum | Sat Oct 29 20:29:30 EDT 2016 | adamjs
Posting here because all the threads asking for feedback on it are locked. We have been extremely happy with the 4300 tacky flux for BGA attachment. Not only is it both washable and no-clean (i.e. wash-optional), it was also the only tacky flux tha
Electronics Forum | Sat Sep 18 12:10:19 EDT 2004 | Steve Gregory
I have a question about solder masking via's in a BGA pattern, and want to see if I'm thinking correctly about this. This problem is kind of along the same line as Carol's problem earlier. I think it's a bad idea to leave the via's free from solder
Electronics Forum | Wed Jul 31 14:08:22 EDT 2002 | Dave G
Used this paste on ENIG boards W/O N2 and had very good results. (0402's,BGA's,16mil FP) Never had the need to use N2 with this paste on our products. Running with N2 shouldn't hurt anything. The wetting properties should get even better than they ar
Electronics Forum | Fri May 23 09:27:37 EDT 2014 | emeto
Hello, these pads look so clean.....I am not sure you had a good solder connection there. I would check the following. 1. Is the part RoHS in a lead process 2. X -ray boards after reflow(I assume you will see head in pillow) 3. Check for board con
Electronics Forum | Tue Aug 02 15:03:37 EDT 2016 | davef
On a previous black pad experience we soldered a wire to a fiducial and did a pull test to failure. On the black pad board the wire and solder pulled of clean leaving the fiducial on the board. On good boards the copper came off with the wire. If you
Electronics Forum | Fri Apr 29 14:16:16 EDT 2011 | ppcbs
Below is the long explanation. This defect is most commonly found with BGA components, but can arrise with all components. I see it happening more now with lead free boards that are being assembled with a no clean flux. Best short term remedy is t
Electronics Forum | Mon Oct 20 11:44:41 EDT 2008 | jdumont
Good morning all, we have been having some random intermittent connections on some BGAs lately on ENIG finished boards. Can you take a quick look at this picture (link) and let me know if it looks like a possible black pad occurrence? The picture sh
.gif)
.gif)
