Electronics Forum | Tue Sep 07 10:24:49 EDT 2021 | leeg
Has anyone had much experience of using the "POGO" (Spring Loaded pins during SMT? If so what issues did they encounter initally?
Electronics Forum | Tue Sep 07 16:49:49 EDT 2021 | davef
Talk to us more about your application. Are you talking about ICT test head fixturing or adding pogos to the board during assembly? Or ...
Electronics Forum | Wed Sep 08 11:26:08 EDT 2021 | kumarb
Use a free cloud service like udrop or wetransfer. From your description, the plating is coming off the pogo pin itself ? Also, unless you absolutely cannot sub the part, consider the following vendor - have others as well that service the 'pogo p
Electronics Forum | Mon Sep 27 11:40:50 EDT 2004 | grayman
use water soluble solder paste is the cure for your problem. but if you insist of using NC change your pogo pins to pointed pins.
Electronics Forum | Wed Sep 08 19:58:17 EDT 2021 | kylehunter
Yes, we soldered some Mil-Max pins on a functional test board before. Utter nightmare. We managed to finally get them on, but yes, terrible wetting, and they act as total thermal sinks. Make sure to oversize you pads.
Electronics Forum | Mon Jul 31 18:34:30 EDT 2023 | emeto
I have done some of these. Pin in paste process with generous amount of paste to fill the barrel properly. Pick and place process is tricky too, but if you get them on tape and reel, you can have a custom nozzle and have them placed.
Electronics Forum | Tue May 21 21:28:00 EDT 2013 | ultimatejoker
Wear surface. During the testing, the pogo pin will keep poking the surface of the pad. Loadboard pad is another name for PCB Pad. We call it as loadboard pad
Electronics Forum | Thu Aug 13 05:28:45 EDT 2015 | dilogic
We had occasional problems and usually solve it by pulling out pogo pins slightly to extend them a bit... Also note that electric feeders have "reel empty" sensor that gives the same error message (if you are using cut tape strips without reel)
Electronics Forum | Tue Sep 07 15:23:20 EDT 2021 | majdi4
1 ) Component is not Rohs : Material analyzes confirm that they contain lead over than < 1000ppm 2 ) upper piston blocked after reflow 3 ) wetting was unstable and slow due to heat transfer will you produce with ??
Electronics Forum | Wed Sep 08 11:33:12 EDT 2021 | stephendo
Strange finish on the pads? So no solder left on the pad? Pad on the board or pad on the part? Does the jig go through the oven with the board? If so I would recommend sacrificing a board and drilling a hole in the bottom to have a thermocouple at th
