Electronics Forum | Mon Oct 25 17:06:18 EDT 1999 | William
Mario, If you are looking for a cheap press to do press fit connectors, then you are asking for trouble. Now, and in the long run. ASG out of West Palm Beach makes a very good press. We bought a 5 ton version and are able to press up to about 2500
Electronics Forum | Thu Nov 07 04:25:39 EST 2002 | yngwie
What is VHDN connectors ? how to rework thoe package ? cheers...
Electronics Forum | Fri Nov 08 14:53:11 EST 2002 | davef
Cut the sucka off the board and move on.
Electronics Forum | Tue May 28 16:19:52 EDT 2002 | zanolli
Hello Floyd, Yes, special tooling is required. The tooling usually consists of a press, push-in tooling and support plate tooling. The presses can range from relatively simple arbor type presses to automated hydraulic presses with sophisticated con
Electronics Forum | Tue Oct 14 10:21:44 EDT 2014 | fredc
Accuracy of the arbor press might be made better by tightening the adjustable gibs on the ram if any. If you can use support under the board have the ID of the support just slightly larger than the pins being pressed. Janesville Tool makes an accura
Electronics Forum | Wed Feb 09 12:02:15 EST 2000 | Wolfgang Busko
Sal: If it�s not the PCB, what about the connector itself ? Is it from a different production lot with some unregularities ( dimensions, tolerances, pin alignment, material weakness)? How about handling, storage, shipping causes ? Could it be a tooli
Electronics Forum | Wed Feb 09 10:20:26 EST 2000 | Sal
Currently we have started seeing an issue around a scuzzy connector.The problem being that during insertion of this connnector a couple of pins refused to be inserted and as a result fold over, this folding of the pin is causing the pin itself to fra
Electronics Forum | Thu Feb 10 10:49:26 EST 2000 | Sal
The connectors are well within thier specification,and are also checked for misaligned and damaged pins , as regards the cross-section results, all holes are correctly aligned and are well spaced within their tolerance of +/-0.005 (a couple of isolat
Electronics Forum | Fri Oct 26 06:25:56 EDT 2001 | John
Undertaking tricky rework project to remove two BGA's in close proximity to two press fit dip sockets any guideline sone should use??? proceddure ,process control etc
Electronics Forum | Wed Jan 06 23:49:48 EST 1999 | Chris G.
| Hey All you Einsteins out there!! | | I gotta' problem...('course you do Steve, or you wouldn't be bugging the TechNet now would you?) I had a phone call from a acquaintance of mine wanting to bring two prototype boards over to rework a BGA socket