New Equipment | Solder Materials
High Activity, Completely Odorless, No-clean Solder Paste Exceptional print definition Long stencil life Wide process window Excellent wetting compatibility on most board finishes Low voiding Compatible with enclosed printing
Electronics Forum | Thu Aug 17 09:06:26 EDT 2000 | Chad
We are currnetly looking at switching form squeegee's to the Dek ProFlow head system. Just looking for feedback on the performance compared to squeegee's. Also here the ProFlow reduces the amount of waste of solder paste. Can anyone reflect on these
Electronics Forum | Thu Feb 15 15:54:19 EST 2007 | pms
pr, I don't believe there is a differance in performance of the ProFlow head between "Leaded" and "Lead-Free" paste. We have been using the ProFlow for about 4 years now with leaded paste. Yes, some issues to overcome. Mostly in the brand/type of
Electronics Forum | Tue Feb 09 17:24:09 EST 2021 | smtusa
I have a DEK Horizon 02i. Is it easy to swap between Squeegee and cartridge system just by installing the Proflow head assembly?
Electronics Forum | Wed Aug 15 16:25:52 EDT 2018 | ceharperc1
Anyone with a lot of printing experience, especially in proflow process? I am seeing a lot of voids in the bottom of the head after running. Will run with multiple good assemblies with paste volume being between 60% and 150%, out of no where we wil
Electronics Forum | Tue Aug 22 11:25:43 EDT 2000 | Steve Thomas
Just out of curiosity, what's the maximum length print the Pro Flo is capable of? I think the Cross Flow option for the EKRAs that we use only goes up to 350mm, which is way short of what we'd need.
Electronics Forum | Tue Aug 06 11:07:37 EDT 2002 | slthomas
OK, I'll bite. How you can set a stencil down on a printed board and run a squeegee across it (even if it's a proflow head, it's still a squeegee, right?) without disturbing the printed paste?
Electronics Forum | Sat May 15 09:28:44 EDT 2010 | dekhead
I worked with a customer about 2 years ago on a process similar using ProFlow head to put paste in holes for through hole... Similar to Pin in Paste. Somewhat successful; but ran into heat related damage issue from TH components through reflow.
Electronics Forum | Fri Aug 18 13:38:09 EDT 2000 | James
I've heard there might be some problems when using an enclosed print head with water soluble paste. It dries out and compacts in the head. Just the opposite of what is claimed I know, but I hear it is wonderful when using no clean paste. Can anyon
Electronics Forum | Tue Jun 19 07:20:43 EDT 2007 | sami
Dear Fastek. For the Front panel board we are using multible ( 4 boards in one PCB. even thought the balance between the DEK printer and the placers still big 6 sec as a difference. But, may be this is a good idea for the main board? may be also it's
