Electronics Forum | Wed Mar 13 19:56:34 EDT 2013 | hegemon
It has been some time since I programmed a mirtec machine, but I think the technique would be to break the component into different banks of leads with unique locations. U25_Top, U25_Right, U25_LEft, etc... Use the centroid location to check presence
Electronics Forum | Thu May 26 18:55:15 EDT 2005 | bakersm
I have been comparing Mirtec to Yestech on a regular basis. As a AOI trainer and installer, I have seen significant difference between the machines. 1. In a side by side comparison just today, using the same board, I found the following: a. Insp
Electronics Forum | Mon Dec 21 12:09:21 EST 2009 | andrew_11
Hello Dany, i had been invloved in a evaluation at another company between omron,yestech,mirtec,vitech.. I found omron and vitech too long to program for hi mix low volumee. yestech and mirtec programmed quickly. I found the mirtec to find more of t
Electronics Forum | Fri Feb 04 18:41:26 EST 2011 | bdamico
Hello Rodrigo, I am sorry, but this is not the appropriate forum to discuss these matters. Please contact MIRTEC directly regarding your request (203)881-5559. Thank you, Brian D'Amico - President MIRTEC
Electronics Forum | Sat Jan 22 18:16:05 EST 2011 | eadthem
Hey "vpblf" i was wondering if you had herd much from mirtec about fixes for the repair plus issues?(good image duplicated on bad image, no arrows, missing good or bad images, missing problems, problems from a different board showing up under the wro
Electronics Forum | Fri Jan 28 18:44:00 EST 2011 | rodrigo
Yeap, It did! Thanks.
Electronics Forum | Mon Feb 07 02:38:00 EST 2011 | rodrigo
No, thanks.
Electronics Forum | Tue Jan 11 07:26:03 EST 2011 | vpblf
It is nice to hear that we are not the only one's either. I have been told that sometimes the frames get out of order which can cause the images to be incorrect. Even though we may not have altered the program in any way.
Electronics Forum | Fri Apr 04 21:16:56 EDT 2014 | padawanlinuxero
Same option is in the MV-2 Open both programs and then run one of them after inspection turn the board and press start it would change to the other program with no problem.
Electronics Forum | Sat Mar 29 10:04:03 EDT 2014 | josse
Hello there everyone! Our company just bought an AOI Inspection Machine, and that is the Mirtec MV-2HTL 1.3 megapixel, software rev 4. I am trying to create a program that runs the top side first and then asks to run the bottom side consecutively. I
