Industry News | 2012-09-06 10:27:41.0
New Paraquda Pick-and-Place from Essemtec installed in facility
Electronics Forum | Mon Apr 04 12:58:50 EDT 2005 | Roger @ Tyco [Formally Quad]
Passwords for the ZCR / QCR did change with the version of S/W. I believe that from version 2.9 onwards the password to start the S/W from the DOS prompt is "quad" [all lower case]. Pre version 2.9 please type "zcr" [All lower case]. This will enable
Electronics Forum | Tue Apr 25 10:18:58 EDT 2006 | slthomas
This is as much a question of the forum as it is a response, but a small batch oven with programmable profiling, quick response and forced cooling sounds ideal. My question is do they even exist, and if so are they cost prohibitive to the market tha
Electronics Forum | Thu Feb 22 09:56:21 EST 2001 | blnorman
An adhesive, is an adhesive, is an adhesive. Yes most will thin when exposed to elevated temperature, but that's only for a short time. As cross-linking starts, viscosity increases. Having made countless numbers of adhesively bonded samples in the
Electronics Forum | Wed Apr 21 14:32:52 EDT 2010 | remullis
These ovens maintain good profiling as long as you stay on top of maintenance. I had 4 150's and 1 125. The biggest headache is keep the plenums cleaned (very messy). Also the blower motors have been replaced a few times on them as well. If I were yo
Electronics Forum | Thu Sep 29 19:45:23 EDT 2011 | edwaterfall01
The conveyor is programmed to turn off the belts and go into an error condition after 30 seconds if the board has not passed the output sensor on the conveyor. The intent is to indicate a board jam and prevent damage to the board or belts. On convey
Electronics Forum | Fri Nov 04 11:29:46 EST 2005 | JeffP
Jay, I work for a company that manufactures batch reflow ovens however, I will try to be as subjective as possible. For the most part, what others have posted is true. Yes, there is one heating chamber and if the heater does not have enough power
Electronics Forum | Tue Aug 13 17:34:44 EDT 2002 | pjc
The Electra is Electrovert's top-of-the-line wave solder machine. Just about the best you could get. Conveyor concerns should focus on the condition of the extruded rails. A machine that new should not have a problem, buy worth a look see. Find out i
Electronics Forum | Tue Nov 05 06:51:59 EST 2002 | V.RAMANAND KINI
Hi, This is a widely discussed subject and since you have asked a brief explanation, I assume, you are a business man or a top executive in the company venturing in to COB. I waited to see if someone replies to you. May be it is a very old subject
Electronics Forum | Mon Dec 13 19:34:09 EST 1999 | Steve Thomas
Thanks, gentlemen. All points well taken, and some hit pretty close to home. Our pick-and-place programmer assures me that coplanarity isn't the issue because the machine won't (or can't) place parts beyond an acceptable criteria. It's an Amistar
.gif)
.png)
