Electronics Forum | Wed Jul 01 11:33:30 EDT 1998 | Upinder Singh
Hi all. I am trying to put one 20 pin thru hole connector along with the smt components on the PCB. I would appreciate if somebody can guide me in getting thru this process. I also need to know how much bigger the holes on the screen or stencil shou
Electronics Forum | Tue May 12 04:15:48 EDT 1998 | Chris Sargent
Help! We have been doing some trials on Paste Through Hole and have encountered a problem. The screen is designed (as is suggested in technical info re PTH) to give double the paste volume required to fill the void between the pin and via. The pro
Electronics Forum | Fri Jul 03 09:29:19 EDT 1998 | Dave F
| Hi all. | I am trying to put one 20 pin thru hole connector along with the smt components on the PCB. I would appreciate if somebody can guide me in getting thru this process. I also need to know how much bigger the holes on the screen or stencil
Electronics Forum | Sat Jan 19 10:58:23 EST 2008 | slthomas
That's a good idea. We did pull the bridge piece off of one just to see what happens with the receptacles only, so no flux blockage. They flowed great with no blowholes, but also filled with solder. :/
Electronics Forum | Fri Oct 22 19:07:29 EDT 2010 | jry74
To get out of a delivery pinch, I had to pre-tim some connectors because of contaminated leads. Make sure your selective wave speed and XYZ travel are close. Try doing a dry run across the board to preheat the PTH and then go back and solder them.
Electronics Forum | Tue Aug 13 09:47:49 EDT 2002 | johnw
Hi Folk's, a quick and easy? question. Got a card with PTH edge stiffeners fitted to it so we need to flow solder them. Having problems getting hole fill, mainly I think due to 2 things, poor pin to hole ratio and also a bit of oxide. The question i
Electronics Forum | Mon Jan 28 19:58:58 EST 2002 | davef
Well, reflow certainly would increase your preheat, wouldn�t it? On the other hand, some PTH [and SMT] components cannot bear the heat of a reflow oven. Some boards will never see proper barrel fill, because of either: * Design of the board. * Sl
Electronics Forum | Fri May 15 18:18:51 EDT 1998 | Earl Moon
| Help! | We have been doing some trials on Paste Through Hole and have encountered a problem. The screen is designed (as is suggested in technical info re PTH) to give double the paste volume required to fill the void between the pin and via. The
Electronics Forum | Thu Apr 30 22:40:32 EDT 2009 | davef
Selective Wave Soldering DoE to Develop DfM Guidelines for Lead and Pb-Free Assemblies Written by Makram Boulos, Craig Hamilton, Mario Moreno, Ramon Mendez, German Soto and Jessica Herrera Circuits Assembly Magazine, 31 December 2008 19:00
Electronics Forum | Wed Aug 11 15:58:39 EDT 1999 | Doug Philbrick
| We are using a mixed technology process with mostly through-hole parts plus some SMT IC's on the component side and some passive SMT parts on the solder side. We do not have a proper wave soldering machine for doing solder side SMT (double wave or
