Electronics Forum | Mon Jun 29 16:03:24 EDT 2020 | spoiltforchoice
I certainly can on the Paraquda and I suspect the basic algorithms are the same. Slimmer annular rings such as you might get on a plated via hole don't always image quite as well but if for some reason it doesn't pick it up you should be able to inte
Electronics Forum | Mon Dec 28 15:43:22 EST 1998 | Mark D.
We have a new PTH board that utilizes lap pads on the B/S. Some of the pads are paired closely together and are aligned at angles (30,45,60 degrees)to the boards direction of travel through the wave. The pads most always bridge together. I realize th
Electronics Forum | Mon Dec 28 19:28:57 EST 1998 | Chad Haima
| We have a new PTH board that utilizes lap pads on the B/S. Some of the pads are paired closely together and are aligned at angles (30,45,60 degrees)to the boards direction of travel through the wave. The pads most always bridge together. I realize
Electronics Forum | Thu May 08 10:16:17 EDT 2003 | davef
Observations are: * Center most lead of the fuse on the top right of the assembly looks like it has excellent solder flow, but this is PTH. From the amount of solder, it must have been wave or hand soldered. * Center most lead of the fuse on the bot
Electronics Forum | Fri Jun 07 10:28:23 EDT 2013 | danselness
We use a Wave Solder Plated Through Hole (PTH) assembly process to install a TO-220 Chip Package in the PCB board that we manufacture and have experienced lower yields on a number of boards with this component due to Bridges. The bridges on the TO-22
Electronics Forum | Thu Jul 05 19:39:19 EDT 2001 | davef
I had forgotten that it was you that was on the Sipad adventure. [But then again, who can keep track of yer aliases? ;-)] You just go from one adventure to the next. Expanding On Dave�s Hi-Test Flux Method Theory � PASTE: Yes, contact your favorit
Electronics Forum | Mon Jan 04 11:03:14 EST 1999 | Chrys
| | | We have a new PTH board that utilizes lap pads on the B/S. Some of the pads are paired closely together and are aligned at angles (30,45,60 degrees)to the boards direction of travel through the wave. The pads most always bridge together. I rea
Electronics Forum | Thu Jul 20 12:19:24 EDT 2000 | Dave F
Bob: Techniques for removing RFI / RF shields vary according to the size and type of shield. Removing: * PTH RFI / RF shields is as straight forward as the next heat sinking PTH component, often using a solder bath or fountain. * Small SMT RFI /
Electronics Forum | Mon Feb 23 23:50:18 EST 1998 | mike
| Does anyone have any experience with via in pad for | BGAs using conventional thru hole technology? | Steve Joy Steve, I had a customer who had designed a board to use a BGA socket. Well the socket did not work out so we then placed the bga dire
Electronics Forum | Tue Dec 10 10:26:56 EST 2002 | davef
Questions are: * What is the current plating on the connector that is over the "plating of the leads is Nickel (99.9% purity)"? * What are the temperatures and durations at those temperatures that you read on these connector leads? * What solder allo
