Electronics Forum | Fri Jan 05 14:58:36 EST 2018 | dekhead
Information sent to your email.
Electronics Forum | Wed Mar 07 14:55:13 EST 2018 | cyber_wolf
In my experience that error almost always indicates a bad amplifier.
Electronics Forum | Mon Mar 09 17:42:56 EDT 2009 | smellew
ok Please power on the machine & confirmed that M1CP 2 is ok this is the breaker for the 35V & check M1cp1 now look at the drawings at address 1011 & check the axis ready relays Z1 11CS3x 151-GB Closed is ok if open see address 5402 Z1 servo amp is f
Electronics Forum | Tue Mar 23 18:02:54 EDT 2010 | rodrigo
Hi all, We're setting up a cp-65 and we're finding some issues with it. It has a missing 1st solenoid/switch and some nozzle valves on the cam. The biggest issue is this C axis servo error. The proper data was set to a cam speed of 250 (25%). That's
Electronics Forum | Thu Jan 04 21:38:27 EST 2018 | dekhead
Error is occurring during move to fiducial 1 position (from board stop position)? Or during move to board stop position (from park position)? What is error displaying onscreen? Did you also just replace belt(s)?
Electronics Forum | Tue Sep 21 18:46:24 EDT 2010 | slwolbert
Greetings: > > I am having 'Check Servo' issues > with an FCP 2 4000. It will zero set but given a > few minutes afterwards, the check servo alarm > sounds. > > At times the X/Y table will 'coast' > back to beginning position, like the power
Electronics Forum | Wed Mar 11 12:23:08 EDT 2009 | rodrigo
I changed the satus B bit to disable the MTU (still on though). It doesn't wait for the MTU anymore but I get a Emergency and Door NG errors. The relay tripped. Is there a way to completely disable the MTU (leave it off) and power up the IP? This sho
Electronics Forum | Sat Sep 05 02:34:19 EDT 2009 | martinphill
check R-axis mechanical backlash... After checking R Axis Backlash, Coupling. If still the Problem continues. We have the same issues & when we asked Jagadeesh Rajagopalan , he suggested following action item Check the servo Error display. If it i
Electronics Forum | Mon Mar 04 13:48:53 EST 2013 | orlando216
Greetings to all, I have the following problem with an IP-3 from Fuji, At display is says: Cannot Move: X1 Axis Feeding aborted Servo Alarm X2 AXIS Servo Ove
Electronics Forum | Mon Mar 09 13:07:52 EDT 2009 | rodrigo
Hi all, Our IP-2 stop working during production with a Servo NG error. Turning it on and off just goes back to the same thing or "Turn servo power on" error message. I was checking the power for the servo amps and I found a 35VAC line that is missin
