Electronics Forum | Mon Feb 19 08:38:05 EST 2007 | realchunks
Are your pads on the board aligned correctly? I've seen this a lot lately. Pads on opposite sides are not aligned correctly. This causes the part to twist. If you have the Gerber and a way to check it, it's worth the 3 minutes to check.
Electronics Forum | Tue Sep 22 10:52:31 EDT 1998 | Wayne Bracy
| We have problems with voids when we solder lids to | ceramic flatpackages. | The sealring of the package is gold(100 micro inches or 2.5 micro meters)with a underlayer of Nickel | The solder is attached to the lid (preform) and the solder material
Electronics Forum | Mon Nov 29 18:23:19 EST 2010 | comprep
Has anyone had any success with placing BGAs with the Quad QSP-2? We have been having alignment issues with BGA placement but our placement of 0402 parts is dead on. We have worked through the calibration and it seems to be correct.
Electronics Forum | Fri Jun 30 09:10:12 EDT 2006 | andyspaziani
We are having continual QuadAlign issues with a 1997 vintage QSP2. Every part on the machine has been replaced� now they want to replace the entire head on gantry one. Does anyone have any experience in this area? Sincerely, Andy Micro Air, Inc.
Electronics Forum | Thu Sep 18 14:59:46 EDT 2008 | bobpan
Check the fuses on the quad align card. There are 2 on each card. They are surface mount type. Typically one of these have blown. Good luck
Electronics Forum | Fri Dec 19 17:11:24 EST 2014 | guts1872
My QSP2 motors keep shutting off with an error message on the screen that says Z1 motion fail. Z safe motion motion failed due to previous error. When homing the heads I observe the servo amp indicator LEDs. They are all green while the gantries are
Electronics Forum | Wed Jun 19 10:11:59 EDT 2019 | jamesn
Hi to everyone I hope someone can help me with a problem I have on a Quad QSP-2. when calibrating ( Or trying to use ) Feeder Bases 2 and 4 on gantry 2 Im getting small amounts of accumulative drift in the X axis. I have changed the servo amplifier
Electronics Forum | Thu Jun 06 05:29:09 EDT 2019 | heinar
Hallo...Quad have problem with z, going to wrong. Parst to high and can not measuring. No errors. Have some body this problem and solutions? Thank you.
Electronics Forum | Tue May 31 15:29:09 EDT 2011 | leemeyer
I have a QSP-2 which I assume is in the same family as the QSA-30. I compared the diagram that is in the service manual with a board from a 2-C and they appear to be the same. Your best bet would be to contact PPM at http://www.goppm.com. They shoul
Electronics Forum | Wed Jun 01 10:02:56 EDT 2011 | bobpan
Those cards are all different. The c-series stands alone by itself while a qsp2 and qsa-30 mount into a slot. They were all manufactured seperately for each machine. I would purchase a new refurbished one for the 2c machine and forget about the other