Electronics Forum | Mon Oct 09 13:36:30 EDT 2006 | ppminc
Phil, The QSA-30 was built by Sam Sung, Sold by Quad. Single Head 2 Nozzles around 11K CPH Quad does not support the machine but I believe you can get parts direct from Sam Sung. I am not sure if they have a registration fee. The QSA used Quad made
Electronics Forum | Mon Apr 24 07:37:57 EDT 2006 | craig_83
We have the IQ system. The problem that I was having is that when I load one board to the other, I want to avoid the table top changeovers. So I figure if I can make certain tabletops to run certain boards the changeovers would be much less. I though
Electronics Forum | Tue Aug 10 15:21:46 EDT 2010 | tanderson
I'm having problems with Quad QSP-2 pick n place machines recognizing fiducials. We are cleaning the fiducials, but that's tedious and time consuming ( I don't know anyone who routinely cleans them). We have solder mask clearance around the fiducials
Electronics Forum | Tue Jun 12 15:12:47 EDT 2012 | tanderson
We clean (using a pencil eraser) the fiducials on all our PCBs before processing them through a QUAD QSP-2. We're discussing pcb's with our fabricator to see if they have recommendations. Some of our Engineers believe it is the QUAD that's the proble
Electronics Forum | Fri Jun 23 12:38:49 EDT 2017 | jamesn
Hello Please can someone help with a feeder Base Issue I get the message " Warning Base Manager 2 Runtime '7e' Error Wrong Message Parameter " I have swapped the removable bases 1 & 2 over but the fault still lies with base manager 2 I will than
Electronics Forum | Mon Jun 26 09:33:07 EDT 2017 | bobpan
So I am assuming that you are using the IQ feeders option on the machine. First thing I would check is to make sure you don't have an older feeder on the machine. There was a certain point where quad feeders would be 'IQ' capable or not. You may have
Electronics Forum | Thu Jun 06 09:03:48 EDT 2019 | bobpan
If the part is 10mm or less as long as you are scanning it near the top...it should work. The other possible problem is dirt on the quadalign lens. Clean off the lens and watch it when it homes....both heads should home the same way. If the head jum
Electronics Forum | Tue Feb 09 10:34:53 EST 2021 | jamesn
Hello Gents I have a problem with the head on gantry 2. I think it needs replacing but in the meantime Can anyone on the forum tell me how to disable it so the machine will initialise and run gantry 1 Ive been told it can be done but they cant rememb
Electronics Forum | Thu May 02 09:08:13 EDT 2002 | darryl
I have a Quad QSP-2 for 5 years and I have had no problems with it. We run it 16 hours per day 6 days a week. Software is good. Service is excellent Quadcare is expensive. The only drawback that I see is tapefeeder repeatability. Seems that the p
Electronics Forum | Fri Apr 07 16:12:37 EDT 2006 | craig_83
I would like to freeze feeders on a global basis. I am tired of table changeovers everytime I run a different board. A good example is today I ran 1 board which went well. I wanted to run a board behind it that had 99% the same parts. I am not necess