Electronics Forum | Wed Sep 02 16:11:29 EDT 2015 | emeto
My guess - GHOSTS!!! :) No seriously, you have to observe more about the timing and the sequence this thing happens. If it is absolutely random(which I doubt), than your machine might have serious problem. And when you say it is moving - is it movin
Electronics Forum | Fri Apr 21 23:37:31 EDT 2006 | SD
My company is very insistant on making our actual production times match the predicted. Perfectly reasonable.... However, the problem is that one operator can beat the predicted rate and another can blow it away 10-fold. I know the problem is tha
Electronics Forum | Thu Mar 06 17:27:17 EST 2014 | bobpan
Does this happen with just 1 gantry? If so...I would think your encoder in that gantry/axis needs cleaned. I have seen digital i/o cards cause this issue. But usually you will notice this when opening and closing the doors. The head would sometimes
Electronics Forum | Sat Aug 18 00:49:56 EDT 2012 | audere
When I see this on my QSP2 it is always caused by the nozzle not seating ideally but I tend to set my tolerances really tight. To test mount a nozzle and look at Z height. Now pick up the part (which in my case will suck the nozzle upward due to the
Electronics Forum | Thu Nov 12 04:40:03 EST 1998 | Galen
| Scott - Good to see things are going well for you. With regard to your comments, Quad has introduced a complete line of Semi-conductor/APT machines (Q Series) that support both SMT and Semi-conductor applications. The machines were introduced in
Electronics Forum | Tue Apr 23 12:17:28 EDT 2002 | binns
I have a couple of questions for you, and a couple of answers. 1. Which model ? (100, IIc, IVc, QSV, QSP ) 2. In reference to how the machine stacks up with Fuji and Panasonic. They have never stacked up. Those families of machines have historicall
Electronics Forum | Wed Jan 23 14:30:09 EST 2008 | operator
Additionally, I have seen the bad align error from incorrect pickup Z. Quad align can freak out sometimes if it sees something it doesn't like. If all else fails I just reboot and 99% of the time the problem goes away.
Electronics Forum | Fri Apr 23 10:53:24 EDT 2010 | evertonsanches
Hello Sir, in this situation I recommend you to check and reconect the conectors of Quad Align Board and also of Quad Align Sensor. Everton - Brasil
Electronics Forum | Thu May 20 10:01:23 EDT 2010 | jmw
Just a slight correction....the quad align card is located at the back rear right of the machine (in a cage). If it is a cyber-optics 4c machine....the laser align card is in the front card rack to the far left.
Electronics Forum | Tue Nov 14 00:08:24 EST 2000 | George
Hi Jax, The alignment pop up only on some parts and it's random axes. This happens every prototype run that I need to adjust the alignment of some parts. Fiducials are correct and okay. Also had done calibration on our machines. I really suspect that