Electronics Forum | Thu Dec 24 14:52:24 EST 2020 | bobpan
Good job, For the comm errors i would try: 1. Reseat all the cables that plug into the white multiplexer that is attached to the back of the computer. 2. Reseat the EPCU card down inside the machine. good luck, Merry Xmas, Bob
Electronics Forum | Wed Dec 23 22:34:22 EST 2020 | bobpan
Hello Marcelo, When you initialize the system in central controller...does it see mvs? Will a different job that you ran before work or does the same error happen? When do you see this error. You can email me at http://www.precision-repairs.com if y
Electronics Forum | Wed Sep 04 12:01:59 EDT 2019 | slthomas
My recollection of the 4c is fuzzy but I know that there's a ribbon cable on the head that gets some abuse when the head rotates. Seems like mine would eventually break at the crimps and I had to replace it a few times. Eventually I bought the parts
Electronics Forum | Wed Dec 23 20:06:26 EST 2020 | marcelorotofrance
Hi, I'm using a "ye olde" Quad 4c Mk2 built in 1995 for eight years. During that period I had to change 3 HDD (now it runs a compact flash with and free DOS), 3 Z-rod bellows,3 laser heads, some monitors, nozzles and misc parts. Despite that it has t
Electronics Forum | Fri Sep 22 15:35:14 EDT 2006 | lheiss
Hello all, Finally ready to run my first 14 up array and the machine picks up the part moves to the placement location, them moves to home and drops the part. The Z axis never moves. I do get a "run error 1" at about the 4th placement (if it was a
Electronics Forum | Fri Aug 30 10:35:54 EDT 2013 | nophsem
Data base Utilities --> Download MOD Codes to assembler) and the motor error # 5 appeared instantly in the handheld.
Electronics Forum | Fri Aug 30 21:54:14 EDT 2013 | nophsem
Well, the error occurs with Mod Code 56 (dispenser enable). Head # 1 has installed this accessory, but we use it very little and it wasn't this time. I probed setting 0,1,2 and 3. I downloaded Mod Codes from controller to assembler, then the error b
Electronics Forum | Tue Sep 03 05:37:06 EDT 2013 | bobpan
It sounds like your dispenser has a problem....The default mod code for 56 is 0 (this should be off). Thats why when you cleared the mod codes the machine was able to home. When you reload your saved mod codes it is probably set to 1. The machine wil
Electronics Forum | Thu Sep 08 13:07:18 EDT 2016 | claudea2
Hello Bob, we changed the nozzle z parameter until we got limit errors and backed up 1 mil. There was a slight reduction in the limit errors on the pickup of the component but it is still a problem. With the mod code we adjust the soft z height to ab
Electronics Forum | Thu Sep 08 15:22:32 EDT 2016 | bobpan
If its a tall part and you are trying to scan it lower than 200 or so...you can have this problem (limit error). Thinking of things to look at.....Is your z-rod spring sticking? Push up on it and it should spring back with NO hesitation...if it does.
