Electronics Forum | Thu Sep 26 10:04:46 EDT 2013 | nophsem
I tested original 'bad' SRX card in the other machine and it doesn't work, same error: SRX Autobaud Motor error #5 With our QUAD 4C, (Machine speed setting) MC 53= 0 (high speed), I changed =1 (low speed), same error
Electronics Forum | Fri Sep 06 11:07:27 EDT 2013 | bobpan
Use the hht and do a function 6.....this will tell you the version of firmware that the machine is running and then you will know which mod code list to go from. good luck
Electronics Forum | Fri Sep 06 11:37:43 EDT 2013 | bobpan
I dont have a list for anything that old. The oldest i have is version 2.10. Check to see if the mod code list that you have says what version it is.....usually its on the top of the document
Electronics Forum | Tue Oct 01 11:56:57 EDT 2013 | bobpan
I would try the following: 1. Back up your mod codes or make sure they are up to date. 2. Turn off the machine and slide a business card between the battery and the clip located on the EPCU card in the front card rack. 3. Download back in your mod co
Electronics Forum | Tue Mar 10 17:26:35 EST 1998 | Jeremy Smith
Looks like it's more operator error that anything. I have 3 Qsp2's and a 4c. With exception of some software bugs they have been grate
Electronics Forum | Fri Nov 18 08:35:20 EST 2011 | bobpan
try this..... I think there is a coupling for the theta motor....make sure both set screws are tight.....maybe the theta is slipping. Make sure there are no bright lights shining into the machine....maybe even throw a dark cover over the top and try
Electronics Forum | Mon Nov 21 14:22:22 EST 2011 | mosborne1
Tim, The main controller card has a battery on it. Power down the machine and disconnect power. Stick a credit card between the battery and the clip. Hold for at least 60 seconds. Then power back up the machine. Make sure to have yourmod codes writ
Electronics Forum | Fri Sep 06 12:34:00 EDT 2013 | bobpan
Your firmware is so old that the problem is not in the mod codes anyways. You have a problem with the cyberoptics head. If its not working at all, i would remove the lens assy on the front side where the cable plugs in and blow out the unit. Maybe if
Electronics Forum | Tue Nov 08 15:07:51 EST 2011 | gosswald
I have been in the process of setting up a Quad 2C that lost its mod codes myself. Have you cleaned the glass encoder strips for X and Y? I was getting alot of motor errors until I cleaned them and I believe it was the error 4. Hope this helps.
Electronics Forum | Wed Sep 20 10:05:10 EDT 2006 | SWAG
Not familiar with 3C/4C but if the head is similar design to Samsung then you might consider flushing the tubes and airlines that go to the nozzles. We used to disconnect the airlines at the top and run cleaner down through the tubes. We would then