Electronics Forum | Thu May 26 14:06:03 EDT 2016 | stevedc
I did clean both lenses from the outside and checked all the MOD codes. I even removed the battery to reset everything and re-programmed all the codes but to no avail. I will strip it down and fully clean it to see if that helps. Just strange that
Electronics Forum | Fri Feb 01 19:12:18 EST 2013 | marcelorotofrance
Hi, I have a QUAD 4C mk2. I taught pickups and places from HHT. If I test them individually (RUN STEP PICK/PLACE etc...) before building the sequence, everything runs ok. After the sequence was built, everything goes wrong. Every PICK or PLACE ends i
Electronics Forum | Fri Sep 06 02:34:37 EDT 2013 | rollon65
Hi Marcelo The two machines I mentioned are the American type but they have an internal transformer fitted to convert from 110 to 220 Volts for U.K. Incidentally only one of the machines does it on a regular basis whilst the other one is mostly O.K
Electronics Forum | Wed Sep 20 18:07:52 EDT 2006 | lheiss
It wasn't my idea to reset all the mod codes. I was just doing what the guy on the other end of the phone said. I'm working on straighting the Z-Rod now and have a new one on the way as well as a grease kit. I've only checked with one company on d
Electronics Forum | Fri Nov 18 16:26:17 EST 2011 | olddog
Hi again Bob, I checked the theta motor coupling and the set screws are definately tight. I noticed that the theta motor drives an snti-backlash gear (nice design) so there is no play there. It appears that the gear drives a slotted shaft which is d
Electronics Forum | Fri Jul 19 18:21:17 EDT 2013 | microaide
We recently purchased some used Quad 4C machines. One of them does not seem to keep a stable origin reference point. I teach the nozzle and component pickup coordinates, then suddenly everything seems to be off by .030 to .040 inches in the X axis. I
Electronics Forum | Wed Sep 20 16:24:19 EDT 2006 | bobpan
Larry, I would suggest not changing mod-codes on a machine that you dont know very well and that should solve the damaged z-rod problem. What you should do is get someone into your company to train you on the basic's of operating the machine. The $22
Electronics Forum | Fri Sep 06 05:09:13 EDT 2013 | bobpan
Mod code 69 in early firmware versions was laser align part size addition but in later versions is was laser intensity.....if its set to 0 try it at 250 and see what it does....if this doesnt work....set it back to 0. It seems that when you put somet
Electronics Forum | Thu Nov 17 17:44:19 EST 2011 | bobpan
Tim, 1. You dont need the vacuum verify if the quadalign is working properly. If you have the part quad-aligned and dont have alignment type at 0 it will never 'not' place a part. More or less...the vac verify was needed for the chucking machine (3c)
Electronics Forum | Wed Sep 25 13:25:13 EDT 2013 | nophsem
Hello bobpan: The machine is a QUAD 4C I turn on the machine and get the error: SRX AUTOBAUD Motor error #5 I removed the battery and then put it back in, the error remains. I removed the battery without put it back in...and turn on the machine,
