Electronics Forum | Thu Nov 17 05:11:09 EST 2011 | bobpan
wow.....lets try some more things....... first....i think quad align error 0 has something to do with the theta number not being at 0,6000,12000,18000. I am not for sure about that but check it out by doing a function 3 on your pickups. second.....
Electronics Forum | Thu Jan 02 04:56:38 EST 2014 | bobpan
Here is a couple of things to look at: 1. Make sure the boards are plugged into the correct position. Also just leave out the transport card to see if its hanging up the machine. The transport board should be the board all the way to the right. 2. M
Electronics Forum | Fri Sep 27 21:01:52 EDT 2013 | marcelorotofrance
Hi everybody This week I was creating a new program by means of saving a successfull existing one under a new name with "UTILITIES/Data Base Utilities/Select/Copy/Delete Board Program" on CC7.54, to seize useful parts without having to teach them aga
Electronics Forum | Thu Jul 01 14:34:39 EDT 2010 | claudea2
I purchased a used QUAD 4C -136 and after a few months got the machine running 8 hr shifts. One issue I have come across is feeder drift. I kept re-aligning the feeder pickup positions but they would always change. Finally I got the time to measure
Electronics Forum | Wed Sep 25 09:59:44 EDT 2013 | bobpan
Hello, This is from my old documents....hope it helps. I would first try mod code 53 = 2 first.....if the machine is a 2C. The motor was known for causing this problem after getting old. These are all resolutions for motor error 4. Step Potential P
Electronics Forum | Thu Aug 04 15:07:30 EDT 2016 | sumote
I have seen a similar error on a Quad 4C machine. When setting up the parameters on a tray part there are several points of data you have to input. You have to teach where the center of the 1st part (and you have to know which corner your machine con
Electronics Forum | Wed Nov 09 05:12:43 EST 2011 | bobpan
Motor error 4 is an error that is caused by the machine not reaching a position in a timely matter. Usually its in the x/y axis but also could be z. If you have cleared the mod codes (function 35 shift 7) the machine should home. Usually this problem
Electronics Forum | Thu Nov 17 22:30:01 EST 2011 | olddog
Hi again Bob, I'll go by your item numbers: 1. OK, I'll not worry about it. 2. Somehow, it seems to me that it must be doing something or in Run Step Placements there wouldn't be different behavior for Alignment type 0 vs. other settings. I know I'
Electronics Forum | Thu Nov 17 14:33:02 EST 2011 | olddog
Thanks again Bobpan for all of your help. I hope some of my questions are dumb ones. Regarding "first", the QA error 0, you were right. In checking the setup, for some reason theta was 65227 instead of the 0 that I thought I had set. Regarding "sec
Electronics Forum | Wed Nov 16 14:44:31 EST 2011 | olddog
Bobpan, thank you for your speedy response. As to the items you noted: 1. I did a test of Funct 30 for the first 5 nozzles, 2 times each as follows: noz1 Ht=215 & 219, center=1005 (all nozzles all tests), run out 2.2 & 2.7. Noz2 Ht=228 &228, runout=
