Electronics Forum | Thu Nov 17 15:57:41 EST 2011 | olddog
Hi Bobpan, Regarding "second", the results of the test are no difference - still rejects the part. I tried 2 mils, 3 mils, 5 mils, 7 & 9. I changed the tolerances fron about 15% to 20%+. By the way, I did put on the new nozzle and it is still the sa
Electronics Forum | Wed Nov 16 17:30:29 EST 2011 | olddog
Hi again Bobpan, One thing I noticed when I pulled the z-rod to inspect it was that it was "bearly" finger tight. When I replaced it, I snugged it a bit better (not overtightening). After resuming setting up additioanl placements (this board requires
