Electronics Forum | Wed Sep 04 13:40:46 EDT 2019 | smrsteve
Hello DWL, Thanks for the response. I've measured the components with a micrometer and set the sizes. Maximum tolerance on my machine is 20%, and that's what I'm using. If I do a manual scan, the measurements are exactly right (and what I've set up
Electronics Forum | Wed Sep 04 14:12:26 EDT 2019 | bobpan
It sounds like the vac-verify is not working. There is a command on the hht to turn it off. When turning off your hht will show either 'idle' or enter command' without the V showing anymore. Maybe try the cntrl and vacuum or shift and vacuum. If its
Electronics Forum | Thu Sep 05 08:33:54 EDT 2019 | bobpan
Make sure your placement rotation co-ordinates are correct. If you do a function 3 it will show you. I think they should be in multiples of 6000....ex...6000 = 90 deg. Also check the z axis number. I dont think its cyber or vac related. It is somet
Electronics Forum | Wed Dec 23 22:34:22 EST 2020 | bobpan
Hello Marcelo, When you initialize the system in central controller...does it see mvs? Will a different job that you ran before work or does the same error happen? When do you see this error. You can email me at http://www.precision-repairs.com if y
Electronics Forum | Wed Sep 04 12:01:59 EDT 2019 | slthomas
My recollection of the 4c is fuzzy but I know that there's a ribbon cable on the head that gets some abuse when the head rotates. Seems like mine would eventually break at the crimps and I had to replace it a few times. Eventually I bought the parts
Electronics Forum | Tue Oct 10 12:32:08 EDT 2006 | RLM
Larry, I have had this problem in the past. It turns out that there wasn't enough "Z" on our nozzle pickup locations. When a nozzle change occured the nozzle would not be fully seated on the Z-rod. When the Z-rod is driven down to pick the first part
Electronics Forum | Thu Dec 24 12:43:18 EST 2020 | marcelorotofrance
Hi Bob. When I initialize the system, all functions appears. In "Utilities/Initialize System Comm" option too. I have to confirm yet, but this problem appears to not happen in all programs. The red error message shows when I launch the program. My su
Electronics Forum | Tue Oct 10 11:06:04 EDT 2006 | lheiss
Hi All, I wasn't sure how this would turn out until I ran some production. As I suspected, after every nozzle change the machine dumps the first 3 pickups, checks the nozzle height again (function 30?) and then begins placing with correction with n
Electronics Forum | Wed Sep 04 13:32:22 EDT 2019 | bobpan
Try these things: 1. Do a function 30....your nozzle height should consistently be around 200 +/-20....but whatever number it does find it shouldn't change. (with nozzle on) 2. Most times its the z-bellows....an old z bellows that has a worn out spri
Electronics Forum | Thu Sep 05 07:14:16 EDT 2019 | smrsteve
Hello Bobpan, Thanks for the suggestions. Sorry I didn't reply yesterday as I'd gone home - I'm in the UK, so I'm guessing there's a time difference. Okay, I found the control to turn off the vacuum verify - it's SHIFT - SWITCH/VERIFY. Makes no di
