Electronics Forum | Mon Mar 16 06:12:32 EDT 2015 | bobpan
The first thing to do is to change the z-rod. Sometimes a very old z-rod spring will weaken causing it to reject many parts. If it only rejects parts after a nozzle change....you may need to put some super lube grease on the O-rings on the bottom of
Electronics Forum | Wed Sep 25 13:25:13 EDT 2013 | nophsem
Hello bobpan: The machine is a QUAD 4C I turn on the machine and get the error: SRX AUTOBAUD Motor error #5 I removed the battery and then put it back in, the error remains. I removed the battery without put it back in...and turn on the machine,
Electronics Forum | Fri Mar 13 15:09:20 EDT 2015 | marcelorotofrance
Hello everybody Lately our machine has been working pretty well, but it can’t last too long. Now, during this week’s production cycle, it began to increase the component’s reject rate to alarming levels (obviously the operators reported me when the m
Electronics Forum | Tue Nov 08 07:23:03 EST 2011 | leemeyer
Thanks Bobpan, A function 6 tells me that I have firmware ver IVC 3.05. I keep getting a motor error 4 "The Xand/or Y axis did not reach the commanded position within 500 msec." The battery was dead on this machine so the mod codes were lost. I en
Electronics Forum | Thu Nov 17 15:57:41 EST 2011 | olddog
Hi Bobpan, Regarding "second", the results of the test are no difference - still rejects the part. I tried 2 mils, 3 mils, 5 mils, 7 & 9. I changed the tolerances fron about 15% to 20%+. By the way, I did put on the new nozzle and it is still the sa
Electronics Forum | Wed Sep 25 09:59:44 EDT 2013 | bobpan
Hello, This is from my old documents....hope it helps. I would first try mod code 53 = 2 first.....if the machine is a 2C. The motor was known for causing this problem after getting old. These are all resolutions for motor error 4. Step Potential P
Electronics Forum | Tue May 07 14:47:31 EDT 2013 | ngineer
Z axis seems to move as it should, the flag that goes through the C shaped sensor is not broken. I have gotten it to stay on everytime i start it up now (I did NOT change anything, just unplugged it for awhile, then plugged it back in an flipped the
Electronics Forum | Sun Dec 04 02:20:20 EST 2011 | ngineer
I just got my hands on a Quad IVc, and am trying to find information on a Z-axis Error # 5 @ startup. I haven't really done anything since recieving the machine, I powered on, the Transport moves back and forth, the pc boots and I press enter to log
Electronics Forum | Wed Nov 16 14:44:31 EST 2011 | olddog
Bobpan, thank you for your speedy response. As to the items you noted: 1. I did a test of Funct 30 for the first 5 nozzles, 2 times each as follows: noz1 Ht=215 & 219, center=1005 (all nozzles all tests), run out 2.2 & 2.7. Noz2 Ht=228 &228, runout=
Electronics Forum | Fri Aug 02 08:12:55 EDT 2019 | dfl
Hey guys, I'm using my Quad IV-c for a while now and I already manage to run some batches, but I never used the "Quad Align" feature before, since almost all my boards are 1206 parts, that doesn´t need a ton of precision to align. Anyway,
