Cleveland Cleveland Cleveland Cleveland 0-2567 PACEMASTER 1 M550-03264 PACEMASTER 5 0-2568 PACEMASTER 1 M621 DC DRIVE 0-3270 PACEMASTER 2 M621N DC DRIVE 10 SENSOR CONTROL M621R DC DRIVE 100 CONTROLLER M622 1HP DC DRIVE 100-60HP 60HP 460V DC DRI
Cleveland Cleveland Cleveland Cleveland 0-2567 PACEMASTER 1 M550-03264 PACEMASTER 5 0-2568 PACEMASTER 1 M621 DC DRIVE 0-3270 PACEMASTER 2 M621N DC DRIVE 10 SENSOR CONTROL M621R DC DRIVE 100 CONTROLLER M622 1HP DC DRIVE 100-60HP 60HP 460V DC DRI
AAMA3535 ANALOG ALARM DIN RAIL MODULE AAMR6436 APOLLO ACCESSORIES ACA10000 ACE10000 ACE20000 ACE30000 ACE40000 ADI INTELLIGENT MESSAGE DISPLAYS ADI2R11A ADI2R11D ADI4T11A ADI4T11D ADI4Y11A ADI4Y11D SIGNAL CONDITIONING DIN RAIL MODULES
Electronics Forum | Wed Nov 27 09:51:08 EST 2002 | Claude_Couture
I have worked with 4c's for two years. The feeders are "tinker toys" with a mechanism that slips, so the pick-up has to be adjusted several times as the reel is used, especially with 13" reels. The worm gear was plastic on the steel shaft of the moto
Electronics Forum | Fri Aug 30 11:31:29 EDT 2013 | nophsem
We have two QUAD 4C working in tandem. 3 months ago the EPCU battery (QUAD # 2) died, then we change it. Then downloaded the MODs from the controller to the assembler(does simultaneously on both machines). All this time we continue to work normally.
Electronics Forum | Wed Aug 28 21:47:22 EDT 2013 | nophsem
HI! We have a QUAD 4C since 8 months . Yesterday the head remained immobile in the position where it put the last component to complete a board and indicates Motor Error # 5 (SRX engine communication time-out) and I don’t know what it means and ho
Electronics Forum | Thu Aug 29 05:01:38 EDT 2013 | bobpan
Motor Error 5 is usually an interlock error. Take off the rear right cover and look at the red and green led's on the driver cards. If they are both lit....you have a door open or if you have carts....a feeder base switch is up. Good Luck
Electronics Forum | Fri Aug 30 10:35:54 EDT 2013 | nophsem
Data base Utilities --> Download MOD Codes to assembler) and the motor error # 5 appeared instantly in the handheld.
Electronics Forum | Thu Aug 29 14:20:17 EDT 2013 | nophsem
Thanks for the response bobpan! LED's on the driver cards work well (green with doors closed and both red&green on with door open), and I don't use the carts. The head doesn't move after power on and inmediately you can listen alarm.
Electronics Forum | Mon Jun 16 11:36:28 EDT 2014 | bobpan
Are both red and green leds on for the driver cards (they are located in the bottom right of the machine). If they are both on then you have an interlock opened. If this is the case....check the side doors....sometimes they are not shut all the way.
