Electronics Forum | Tue Nov 08 07:23:03 EST 2011 | leemeyer
Thanks Bobpan, A function 6 tells me that I have firmware ver IVC 3.05. I keep getting a motor error 4 "The Xand/or Y axis did not reach the commanded position within 500 msec." The battery was dead on this machine so the mod codes were lost. I en
Electronics Forum | Mon Sep 30 15:26:48 EDT 2013 | leemeyer
I have been using Quad 4C's for 15 years and have never come across this error. Everything initializes OK but when I start a program through Central Controller I get an "OUT OF MEMORY" error. I have flushed the Mod codes and re-entered them and have
Electronics Forum | Tue Mar 10 17:26:35 EST 1998 | Jeremy Smith
Looks like it's more operator error that anything. I have 3 Qsp2's and a 4c. With exception of some software bugs they have been grate
Electronics Forum | Mon Feb 04 08:04:39 EST 2013 | marcelorotofrance
Function 30 reads CENTER 1024 RUN OUT 0.0 with any nozzle and without nozzle at all. However I see that nozzle tip stops in front of laser beam. When I interrupt the beam with a piece of paper during Function 30, Z axis travels down until I take it
Electronics Forum | Wed Sep 20 10:05:10 EDT 2006 | SWAG
Not familiar with 3C/4C but if the head is similar design to Samsung then you might consider flushing the tubes and airlines that go to the nozzles. We used to disconnect the airlines at the top and run cleaner down through the tubes. We would then
Electronics Forum | Tue Nov 08 15:07:51 EST 2011 | gosswald
I have been in the process of setting up a Quad 2C that lost its mod codes myself. Have you cleaned the glass encoder strips for X and Y? I was getting alot of motor errors until I cleaned them and I believe it was the error 4. Hope this helps.
Electronics Forum | Fri Feb 01 19:12:18 EST 2013 | marcelorotofrance
Hi, I have a QUAD 4C mk2. I taught pickups and places from HHT. If I test them individually (RUN STEP PICK/PLACE etc...) before building the sequence, everything runs ok. After the sequence was built, everything goes wrong. Every PICK or PLACE ends i
Electronics Forum | Fri Nov 18 08:35:20 EST 2011 | bobpan
try this..... I think there is a coupling for the theta motor....make sure both set screws are tight.....maybe the theta is slipping. Make sure there are no bright lights shining into the machine....maybe even throw a dark cover over the top and try
Electronics Forum | Fri Aug 16 03:44:12 EDT 2013 | rollon65
Hi. Sorry I don't have an answer for this but I have the same problem in the "Y" axis on one of my 4Cs after the machine has run for around 4 hours. The machine seems to partially correct for the pick-ups being off as the placements are fairly good
Electronics Forum | Fri Sep 06 02:34:37 EDT 2013 | rollon65
Hi Marcelo The two machines I mentioned are the American type but they have an internal transformer fitted to convert from 110 to 220 Volts for U.K. Incidentally only one of the machines does it on a regular basis whilst the other one is mostly O.K
.jpg)
