Electronics Forum | Fri Jul 19 18:21:17 EDT 2013 | microaide
We recently purchased some used Quad 4C machines. One of them does not seem to keep a stable origin reference point. I teach the nozzle and component pickup coordinates, then suddenly everything seems to be off by .030 to .040 inches in the X axis. I
Electronics Forum | Wed Jun 01 11:02:57 EDT 2016 | claudea2
I have 3 used Quad 4Cs and the nozzle changer on one machine never worked. I decided to troubleshoot it this week. I repaired the changer by changing a defective optical sensor but I still get error 17 when I try a run-step nozzle 1, 2 or 3. Error 17
Electronics Forum | Wed Sep 25 13:25:13 EDT 2013 | nophsem
Hello bobpan: The machine is a QUAD 4C I turn on the machine and get the error: SRX AUTOBAUD Motor error #5 I removed the battery and then put it back in, the error remains. I removed the battery without put it back in...and turn on the machine,
Electronics Forum | Tue Nov 08 07:23:03 EST 2011 | leemeyer
Thanks Bobpan, A function 6 tells me that I have firmware ver IVC 3.05. I keep getting a motor error 4 "The Xand/or Y axis did not reach the commanded position within 500 msec." The battery was dead on this machine so the mod codes were lost. I en
Electronics Forum | Thu Nov 17 05:11:09 EST 2011 | bobpan
wow.....lets try some more things....... first....i think quad align error 0 has something to do with the theta number not being at 0,6000,12000,18000. I am not for sure about that but check it out by doing a function 3 on your pickups. second.....
Electronics Forum | Thu Jul 01 14:34:39 EDT 2010 | claudea2
I purchased a used QUAD 4C -136 and after a few months got the machine running 8 hr shifts. One issue I have come across is feeder drift. I kept re-aligning the feeder pickup positions but they would always change. Finally I got the time to measure
Electronics Forum | Thu Aug 04 15:07:30 EDT 2016 | sumote
I have seen a similar error on a Quad 4C machine. When setting up the parameters on a tray part there are several points of data you have to input. You have to teach where the center of the 1st part (and you have to know which corner your machine con
Electronics Forum | Thu Nov 17 14:33:02 EST 2011 | olddog
Thanks again Bobpan for all of your help. I hope some of my questions are dumb ones. Regarding "first", the QA error 0, you were right. In checking the setup, for some reason theta was 65227 instead of the 0 that I thought I had set. Regarding "sec
Electronics Forum | Wed Nov 16 14:44:31 EST 2011 | olddog
Bobpan, thank you for your speedy response. As to the items you noted: 1. I did a test of Funct 30 for the first 5 nozzles, 2 times each as follows: noz1 Ht=215 & 219, center=1005 (all nozzles all tests), run out 2.2 & 2.7. Noz2 Ht=228 &228, runout=
Electronics Forum | Wed Nov 16 17:30:29 EST 2011 | olddog
Hi again Bobpan, One thing I noticed when I pulled the z-rod to inspect it was that it was "bearly" finger tight. When I replaced it, I snugged it a bit better (not overtightening). After resuming setting up additioanl placements (this board requires
.gif)
.png)
