Electronics Forum | Tue Jan 11 13:28:14 EST 2011 | jmw
0603 and up should be no problem on the machine. If you are doing under 25 mil pitch the machine needs an upward camera to repeatably place the parts. You will always lose the first 10 or so parts with cut tape but that should be about it. Repair par
Electronics Forum | Mon Oct 09 13:36:30 EDT 2006 | ppminc
Phil, The QSA-30 was built by Sam Sung, Sold by Quad. Single Head 2 Nozzles around 11K CPH Quad does not support the machine but I believe you can get parts direct from Sam Sung. I am not sure if they have a registration fee. The QSA used Quad made
Electronics Forum | Mon Nov 09 15:58:09 EST 2009 | cellis
The biggest thing you will not get is the vision system like this. The 7722 has flying vision for most components and an upward looking vision camera for large components and BGA's. The older Quads had the Quad Align system which is laser vision.
Electronics Forum | Wed Sep 04 13:58:36 EDT 2019 | smrsteve
Hello Bobpan, Thanks for the response. 1. Function 30 gives me a consistent 182-185, even after nozzle changes. I can vary this by changing mod code 15 and I have been advised to aim for 90-110, but it doesn't seem to make any difference so I've go
Electronics Forum | Thu Mar 02 04:47:24 EST 2006 | bobpan
If you have an older machine that has cyberoptics you might want to try to put a pickup theta of 90. I believe there was a problem with that type of part. Also use non-leaded alignment and scan the part near the top of it. As for 0402 parts.........
Electronics Forum | Wed Sep 04 09:47:41 EDT 2019 | smrsteve
Hello All, I've just bought a Quad 4c pick & place machine. It's so close to actually building boards, but just doesn't quite get there. I was wondering if there's somebody out there with experience of these machines that might be able to help...?
Electronics Forum | Wed Jan 30 12:53:58 EST 2008 | tonyamenson
In approximately one month I am installing 2D at our DEK print station. We are going with the basic (cheap) software options and 2D camera. After it is up and running we will determine if it is indeed useful. At that point we will decide on the adva
Electronics Forum | Thu Jun 22 10:23:14 EDT 2006 | cuculi54986@yahoo.com
I'm no AOI expert by any means, however I spent a few minutes one time about 4 years ago working on an old CR Technology (or is it CR Technologies?) machine so I've been chosen by my company to be the "technical guy" for our AOI evaluation. We are l
Electronics Forum | Sun Dec 10 11:55:16 EST 2000 | Bob Willis
The following may be of interest to you. INTRODUCTION TO X-RAY INSPECTION All text Copyright Bob Willis, EPS INTRODUCTION TO X-RAY INSPECTION The use of X-ray inspection is becoming very popular due to the increased use of Ball Grid Array (BGA)
Electronics Forum | Sun Dec 10 11:55:28 EST 2000 | Bob Willis
The following may be of interest to you. INTRODUCTION TO X-RAY INSPECTION All text Copyright Bob Willis, EPS INTRODUCTION TO X-RAY INSPECTION The use of X-ray inspection is becoming very popular due to the increased use of Ball Grid Array (BGA)