Industry News | 2017-07-07 17:15:03.0
Carlsbad, CA – July 7, 2017: Machine Vision Products (MVP) today announced it would be demonstrating its Die Wire Metrology System (DWMS) and Semiconductor Automated Optical Inspection solutions at the Semicon West exhibition. These latest capabilities are available on MVP's 2020 and 850G Platforms. Applications demonstrated will include die wire metrology, wire bond, wafer and surface inspection capabilities. The exhibition is at the Moscone Center in San Francisco from July 11-13, 2017. Machine Vision Products are exhibiting at booth #7724 in the West Hall (Level 1).
Electronics Forum | Fri Apr 23 10:53:24 EDT 2010 | evertonsanches
Hello Sir, in this situation I recommend you to check and reconect the conectors of Quad Align Board and also of Quad Align Sensor. Everton - Brasil
Electronics Forum | Thu May 20 10:01:23 EDT 2010 | jmw
Just a slight correction....the quad align card is located at the back rear right of the machine (in a cage). If it is a cyber-optics 4c machine....the laser align card is in the front card rack to the far left.
Electronics Forum | Fri Apr 23 09:13:04 EDT 2010 | kdaglio
for the last couple of days when i power up our quad iv, i get assembler is off errors. i cannot get the machine and the quad align to start. any help is gratly appreciated.
Electronics Forum | Thu May 20 09:47:25 EDT 2010 | pforister
Is this a single head Quad IVc or a dual headed line? if it is a dual line you can swap the align cards in the front bay between the two heads and see if the symptom follows. The card on the far right is a transport card, shouldn't need to swap tha
Electronics Forum | Mon Nov 29 18:23:19 EST 2010 | comprep
Has anyone had any success with placing BGAs with the Quad QSP-2? We have been having alignment issues with BGA placement but our placement of 0402 parts is dead on. We have worked through the calibration and it seems to be correct.
Electronics Forum | Wed Jan 23 14:30:09 EST 2008 | operator
Additionally, I have seen the bad align error from incorrect pickup Z. Quad align can freak out sometimes if it sees something it doesn't like. If all else fails I just reboot and 99% of the time the problem goes away.
Electronics Forum | Wed Jan 23 14:26:52 EST 2008 | operator
I have seen the bad alignment error many times and never had to replace the head for it. It usually has something to do with the laser windows being dirty or cracked. Also it could be your profile settings. Make sure all of these things are perfect b
Electronics Forum | Wed Jan 23 11:28:47 EST 2008 | tbkonrad
Help! Since last Friday i have been having issues with a Quad qsv-1, it all started with a quad align error, i found there to be a small quantity of grease covering the lenses on both quad align sensors. I wiped the grease off and then everything s
Electronics Forum | Wed Jan 23 13:02:35 EST 2008 | tbkonrad
Thanks for the info. I called Mike Tieman earlier and he recommended I do the exact same things. He said that there should be very little resistance on the theta of the Z-rods, (not the case) so he recommended that the P4 head be replaced. Mike is
