Electronics Forum | Wed May 25 22:32:28 EDT 2016 | stevedc
So, I haven't used my Quad 4C for a while and when I started everything back up to run a new board it appears that the Quad align is in need of calibration. When I pick up a component and do an LAE measurement on it it shows the part center location
Electronics Forum | Thu May 26 15:16:28 EDT 2016 | bobpan
oh ya....i forgot....to verify this....turn off all the extents for the parts and just pick them and place them....if they are very close to where they should be then it is the quad align causing the problem....this is how you can verify it. Copy the
Electronics Forum | Thu May 26 17:45:36 EDT 2016 | stevedc
Thanks for the thoughts. I will try a few things tonight so see if I can clean anything from the windows. As always, thanks for your thoughts and time :) BR, Steve
Electronics Forum | Fri May 27 09:27:56 EDT 2016 | bobpan
Glad I can help....if you have any other questions...go to my web page @ www.precision-repairs.com Bob
Electronics Forum | Thu May 26 14:06:03 EDT 2016 | stevedc
I did clean both lenses from the outside and checked all the MOD codes. I even removed the battery to reset everything and re-programmed all the codes but to no avail. I will strip it down and fully clean it to see if that helps. Just strange that
Electronics Forum | Fri May 27 00:18:15 EDT 2016 | stevedc
Soooo.... I started to take the laser off last night to clean it and decided to put it back on to do some more measurements to see if anything obvious turned up and lo and behold it is not good !!! Most likely cause I can think is that you were righ
Electronics Forum | Tue Sep 25 13:03:19 EDT 2012 | saduquette
Thanks bobpan. As we're a real small shop, I'd like to try and repair the board myself. Does anyone know where I can get a set of maintenance/repair manuals for a Quad 4C? At least the schematics for the Quad Align board would help for
Electronics Forum | Mon Oct 01 05:33:15 EDT 2012 | bobpan
wow....nice job....now go get some boards ran...haha!!!
Electronics Forum | Tue Sep 25 05:58:16 EDT 2012 | bobpan
I believe the Led's should flash 3 times when the card is booting up/ powering up normally. There was no board troubleshooting back in the day and we just replaced the card. Make sure the metal cover is grounded to the machine.....this sometimes caus
Electronics Forum | Tue Sep 25 13:33:02 EDT 2012 | bobpan
I dont think you are going to find schematics for that board. Looking through my old stuff....i dont have it and i dont recall it being in the schematics. Maybe someone else can get you a set of schematics though. Good Luck