Electronics Forum | Mon Apr 24 07:37:57 EDT 2006 | craig_83
We have the IQ system. The problem that I was having is that when I load one board to the other, I want to avoid the table top changeovers. So I figure if I can make certain tabletops to run certain boards the changeovers would be much less. I though
Electronics Forum | Tue Aug 10 15:21:46 EDT 2010 | tanderson
I'm having problems with Quad QSP-2 pick n place machines recognizing fiducials. We are cleaning the fiducials, but that's tedious and time consuming ( I don't know anyone who routinely cleans them). We have solder mask clearance around the fiducials
Electronics Forum | Tue May 07 13:42:45 EDT 2013 | tanderson
These are dropped/mis-placed by the machines. We have older Quad QSP-2's. My concern is it's easy for the operators to overlook the dropped parts, keep running the job and when they're done, throw away parts (inexpensive resistors aren't such an issu
Electronics Forum | Wed Mar 19 17:18:24 EDT 2014 | aybars
I would suggest to check your servo amps. on both gantries and both axis.Does it rattle both heads or just one? Since you did not specify this in your question,I will say check all 4 servos in the back side of your machine.Hope this will help and goo
Electronics Forum | Mon Jun 26 09:33:07 EDT 2017 | bobpan
So I am assuming that you are using the IQ feeders option on the machine. First thing I would check is to make sure you don't have an older feeder on the machine. There was a certain point where quad feeders would be 'IQ' capable or not. You may have
Electronics Forum | Thu Jun 06 09:03:48 EDT 2019 | bobpan
If the part is 10mm or less as long as you are scanning it near the top...it should work. The other possible problem is dirt on the quadalign lens. Clean off the lens and watch it when it homes....both heads should home the same way. If the head jum
Electronics Forum | Wed Jul 03 06:52:27 EDT 2019 | bobpan
Seems to be fighting to hold its position. 1. Check for anything worn out...possibly idler bearing/pulley and/or the belt. 2. Maybe it could use servo tuning...this may help but usually servo tuning is not that critical. 3. Clean the scale and the
Electronics Forum | Wed Dec 20 10:04:07 EST 2017 | junkeymonkey246
Hello there, I work at Redcom Laboratories in Victor NY. I'm a student and new to being a machine repair technician. I'm having some bother with one of our TYCO QUAD QSP-2 machines. I keep getting the errors: "WARNING: Head#2 Nozzle RUNOUT=27.1 mi
Electronics Forum | Thu Jun 03 13:11:02 EDT 2004 | Scott B
We had an existing Mydata MY15 line and inherited 2 Quad lines (QSP2 and QSX1). We eventually had to get rid of the 2 Quads (major software and hardware issues) and have replaced these two machines with an addition single Mydata MY15 and are getting
Electronics Forum | Fri Apr 07 16:12:37 EDT 2006 | craig_83
I would like to freeze feeders on a global basis. I am tired of table changeovers everytime I run a different board. A good example is today I ran 1 board which went well. I wanted to run a board behind it that had 99% the same parts. I am not necess
