Electronics Forum | Tue Dec 19 11:49:46 EST 2023 | jeana
Hi Everyone ! On our endeavor to get reliable pick and placing with our "new" Quad IVc, we got weird behaviours of the QuadAlign system. When we received the machine the glass of the laser side was cracked, so we removed it and it started working
Electronics Forum | Tue Sep 26 15:09:17 EDT 2006 | slthomas
I hope that you don't miss that data later on. My suggestion of changing align type to "2" (in the extent data) eliminates the alignment step but leaves the data intact.
Electronics Forum | Fri Jun 28 09:48:32 EDT 2013 | island2013
Hi Dennis, Did you find your Aligners? We have this part in stock. Visit our Spare parts inventory at http://www.islandsmt.com or give us a call.
Electronics Forum | Wed Oct 23 10:10:39 EDT 2013 | cano1912
Ryan, found the aligners form a company here in Florida called Island SMT. They carry a lot of spare parts for different machines.
Electronics Forum | Mon Sep 25 09:42:51 EDT 2006 | slthomas
It sounds like it's just failing the laser align step. Try changing the align type for the part to "2" and see if it places it. If it's failing the laser align and you have valid part dimensions I can't help much but you might consider opening up th
Electronics Forum | Fri Mar 11 14:30:03 EST 2005 | ???
i agree with changing the head board if the ribbon cables have been changed. I would also check the quad align card and make sure the cables are plugged in tight to it and to the backplane. There is a large connector on the backplane that sometimes f
Electronics Forum | Thu Dec 29 04:19:52 EST 2005 | lvqp72
We've run into a persistent QA error 99 on one of our Quad IVC's. Have checked upon all the obvious and found no bad components. Do appreciate any advice on this problem. Thanks.
Electronics Forum | Fri Jun 30 09:32:19 EDT 2006 | ppminc
Hi Andy, PPM specializes in Quad equipment. We also offer free phone-support for troubleshooting your machines. If you would like please contact us @ 603 895 5112. Shawn
Electronics Forum | Mon Apr 13 14:48:38 EDT 2009 | bobpan
There is also a modify code that if set to 0 the quad-align will not turn on and you will have this error. It is one of the higher mod codes around 60-80......been so long i forget.... Good Luck Bob
Electronics Forum | Fri May 06 07:29:55 EDT 2011 | leemeyer
You got it. You are aware that Quad defines the theta by steps. 0 = 0, 90 = 6000, 180 = 12000 and 270 = 18000.
