Electronics Forum | Wed Jun 05 05:10:10 EDT 2013 | rollon65
Hi all. I already have a pair of Quad 4C Mk2 and purchased a Quad 4C Mk2 CE model secondhand. Some of the machine powers up but not the motor PCBs so the start up sequence stops after the nozzle changer operates with Motor Error #5 on the handheld.
Electronics Forum | Mon May 07 22:25:21 EDT 2001 | Doug Kester
Has anyone heard of a single or double tray holder plate for Siemens Siplace equipment (either OEM or aftermarket). This would be similar to the Universal, Quad, and Zevatech platens for trays that just clip on to the feeder holders. Have only a co
Electronics Forum | Mon Aug 20 05:45:18 EDT 2012 | bobpan
To solve your problem....you should do the following: 1. Super Lube the o-rings on the z-rod bellows. 2. Make sure your head to camera calibration and head to head calibration is good. 3. Line up the nozzle changer pocket positions. 4. Make sure you
Electronics Forum | Thu Aug 16 07:40:27 EDT 2012 | bobpan
Here are a couple of things to look at. 1. Watch the machine run....and if it misses a part....make sure it doesnt blow out the next part being presented. Sometimes the air pressure is too high and the vacuum verify will blow the part out of the poc
Electronics Forum | Wed Sep 20 15:25:15 EDT 2006 | lheiss
Hey All, Thanks for all of your help to date. While running the nozzle height test I noticed that the Z-rod is bent. Probably happened after setting the "X closed loop soft home" back to 50 from 384 which was probably why the nozzle slammed into t
Electronics Forum | Mon Oct 02 16:38:20 EDT 2006 | lheiss
Brad, Thanks for the info. Now that I have my align data set correctly I'm having this problem. I've greased and realigned until I'm blue in the face. If I do a nozzle change then a function 30, press the nozzle on with my finger and do a functio
Electronics Forum | Thu Jul 25 16:20:59 EDT 2019 | bobpan
Top red led is on or off depending on version of tep board. The green leds light when the transport sensor that it communitcates with is seeing a board over it. Tep controller init failure can be one of the following. 1. Check reseat tep card and
Electronics Forum | Tue Jan 17 23:25:55 EST 2012 | ngineer
I think I've got it. 1. Black flat connectors are for the nozzle changers, and whether or not the tab is pushed in or out (depending on whether they are placed in front of one of the blocks on the feeder base doesn't matter at all, the blocks are th
Electronics Forum | Mon Jul 22 12:43:31 EDT 2013 | microaide
I don't think it is a loose camera lens. We are actually off on the position of the Z-rod. It's not just the camera position that is off. We really can't change nozzles because the z-rod misses the hole in the nozzle changer. We have repeatedly clea