Electronics Forum | Tue May 31 07:04:20 EDT 2005 | bobpan
Mike, There was a dipswitch that can be changed that will clear the machine settings and reset everything back to defaults. You will also lose your programs so backing up everything is a must. If you need and/or want to do this let me know and i will
Electronics Forum | Mon Feb 06 19:56:07 EST 2006 | bobpan
Ok....that is very vague...but here is the approach i would take. 1. rename permanen.tbl file and reboot 2. rename calibrat.arc file and reboot * both files are located in c:\2kla\gui\guiqsv1* If it fixes the problem....it was a software issue. 3. If
Electronics Forum | Mon Jun 13 19:07:57 EDT 2005 | bobpan
Mike, Right down all the settings you have for your machine (this may take a while). Also back up the programs you want to save. Now....if i can remember correctly.....when looking into the black computer box from the back of the machine...in your bo
Electronics Forum | Wed Jan 23 11:28:47 EST 2008 | tbkonrad
Help! Since last Friday i have been having issues with a Quad qsv-1, it all started with a quad align error, i found there to be a small quantity of grease covering the lenses on both quad align sensors. I wiped the grease off and then everything s
Electronics Forum | Wed Jan 23 14:30:09 EST 2008 | operator
Additionally, I have seen the bad align error from incorrect pickup Z. Quad align can freak out sometimes if it sees something it doesn't like. If all else fails I just reboot and 99% of the time the problem goes away.
Electronics Forum | Wed Jan 23 14:26:52 EST 2008 | operator
I have seen the bad alignment error many times and never had to replace the head for it. It usually has something to do with the laser windows being dirty or cracked. Also it could be your profile settings. Make sure all of these things are perfect b
Electronics Forum | Wed Jan 23 12:35:24 EST 2008 | bobpan
Here is a few things to try.... 1. Spin the z-shaft with your fingers and make sure it is smooth and easy to turn. 2. Check your handling in your profile for the part that the software is locking up on.......You cannot go any slower than 40% or this
Electronics Forum | Fri Apr 23 09:13:04 EDT 2010 | kdaglio
for the last couple of days when i power up our quad iv, i get assembler is off errors. i cannot get the machine and the quad align to start. any help is gratly appreciated.
Electronics Forum | Fri Aug 07 18:09:55 EDT 2015 | bnorton
The power distribution board has 10 green LEDs on. By the time of the error SysFail is still on. Logicomm connected to the Force board COMM2 shows a stream of messages saying "Lantern system not active. Heart Beat = 0"
Electronics Forum | Fri Mar 05 08:06:39 EST 2010 | rgduval
Rob, Had that issue early on when we hooked up our Heller. For us, the problem turned out to be the serial communications port on the computer. I can't say we had the black screen, but, we had comm errors. I'd check the following: 1. Cable betwe
