Electronics Forum | Fri Apr 08 21:39:17 EDT 2011 | jimlas53
Hi, We have a Quad IVc set up with all picks, placements, and sequence working. I have managed to get through several passes with some pain, mainly from SOT-23 parts, but it is getting better. On occasion, when picking from one of three feeders loc
Electronics Forum | Mon Jun 20 18:36:42 EDT 2005 | jsloot
Does anyone have any experience with a QUAD Meridian 1010? Our company has purchased a used machine. We have it installed and running almost smoothly. Getting an error code 3487, description is "Z axis target position in motion board is strange" Anyo
Electronics Forum | Mon Apr 11 15:57:25 EDT 2011 | bobpan
If the feeders that you are having problems with have tall parts in them.....and these are the ones the machine is stopping on.....check to see that you are not scanning higher than what your function 30 nozzle height is. In other words...if your fun
Electronics Forum | Mon Jun 12 11:04:20 EDT 2017 | bobpan
So what your telling me is kind of vague. Does the machine home and go to the front left corner of the machine? If it does....this could be a quad align problem....meaning dirt on the lens or so-forth. You should watch the heads homing in the z-axi
Electronics Forum | Fri Feb 01 07:21:32 EST 2019 | dfl
One of my 8mm feeders is blinking the red led after the pick-up. With both buttons the motor works as expected (forward/backward), but after the nozzle pick-up the motor moves forward and then the red led blinks. pressing the buttons the green led l
Electronics Forum | Sat Feb 02 09:53:49 EST 2019 | slthomas
Commponent pitch programming is performed via the buttons on the feeder. I don't remember enough to walk you through it but there are people here that do - I'm sure you'll get some help shortly. If not, go to http://www.precision-repairs and use th
Electronics Forum | Sun Feb 03 08:46:34 EST 2019 | dfl
SOLVED The LED/phototransistor was a little of the center on the "index wheel" (don't know a better name, its the gear that pulls the component strip). The wheel works with a LED from one side and a phototransistor from the other, through a hole on
Electronics Forum | Sun Feb 03 09:36:29 EST 2019 | bobpan
Good job.... Sorry i didnt see this post...some of us were busy snow tubing over the weekend...haha. Many times over the years....the rubber belt inside the feeder will deposit material inside. Sometimes it ends up on the sensors and blocks the ligh
Electronics Forum | Wed Aug 12 18:06:33 EDT 2015 | bnorton
Here's the end of Logicomm capture on Force COMM2 where it starts the Lantern system not active messages. Couldn't get attach to work. Startup and earlier .ldx file loading omitted ulLoadTasks(): Opening the RFS pseudo device driver ... ulLoadTas
Electronics Forum | Mon Apr 11 08:27:10 EDT 2011 | leemeyer
I have had similar problems before where the machine will intermittently stop with a limit error. Reset the machine and away it goes. Replacing the ribbon cable that runs from the head (37 pin D-sub)has solved this problem. This cable gets flexed a l
winsouce.jpg)