Electronics Forum | Mon Jul 09 11:52:21 EDT 2012 | bobpan
Does it show the ANC in a position on the feeder base in the screen that has the nozzles/hole positions? When you go to optimize ...there is a screen that has something to do with registered ANC.....There could be something there that is incorrect. I
Electronics Forum | Wed Jan 18 06:22:23 EST 2012 | ngineer
I rang out the bases, the connectors are common (i.e from top to bottom, 1-1, 2-2, 3-3,4-4). I also measured voltage on the connectors. Front and back don't have any voltage, and the lights don't come on when I press the buttons. Left and Right ar
Electronics Forum | Thu Jan 19 15:57:29 EST 2012 | ngineer
Yup, that sounds right. I did try one with red on top on one side and white on top on the other side. Oops, blew a capacitor out of the back of the base. If anyone else Has these, here's how it goes to make them work: Top pin on both sides = +12V
Electronics Forum | Mon Oct 09 06:04:47 EDT 2017 | bobpan
Hello Joyce, Usually I use Very Large cable ties and secure the heads in the opposite corners. I also tie up the z rods or put some plastic tube under the top portion to keep them up. Remove the monitor and bracket off the side of the machine...and i
Electronics Forum | Wed Apr 03 07:07:44 EDT 2013 | leemeyer
The manuals will not teach you how to use Autoprogram but they will be a reference once you learn it. First you must configure your system. Try this and let me know how it goes. To Configure a machine: -Under Machine Configuration Select Assembler/S
Electronics Forum | Tue Apr 02 12:53:47 EDT 2013 | microaide
I have entered my machine configuration as much as I can figure it out. I will have two machines. One with tape feeders, and the other with vibratory (tube) feeders and a waffle feeder. I've tried to set this up as best I can. But I get to the screen
Electronics Forum | Tue Feb 07 05:36:30 EST 2012 | ngineer
Yup, that sounds right. I did try one with red > on top on one side and white on top on the other > side. Oops, blew a capacitor out of the back of > the base. If anyone else Has these, here's how > it goes to make them work: Top pin on both
Electronics Forum | Tue May 17 13:10:50 EDT 2016 | rx8pilot
Thank you Bobpan - I tried that sequence but instead of LED's flashing - they were solid and it remains in 4mm mode. After looking closer at the feeders, it appears there are 'SlimPRO' and 'ThinPRO' versions. The ThinPRO version is what PPM manufactu
Electronics Forum | Tue Sep 15 02:17:37 EDT 1998 | Doug Kester
| We are a small contract assembly shop hand placing SMT. We recently received a large contract for SMD that will require placement rates of at least 6,000 CPH. I am looking at Fuji, Mydata, Quad, and Zevatech. I have little experience with automated
Electronics Forum | Tue Jun 07 18:35:38 EDT 2005 | gregp
Rob, I don't have the time to do the research and prove my points. What I know is from 20+ years studying the competition. Any Fuji saleman would tell you that based on the original post the AIM platform is the better choice. Bigger board, more fe