Industry News | 2010-08-17 13:40:20.0
The SIPLACE Team has unveiled its latest placement machine, the SIPLACE SX4. As a high-speed addition to the SIPLACE SX platform, the four-gantry machine sets new standards in terms of placement performance per square meter of floor space – an important metric in the investment decision-making process. With its placement speed of up to 120,000 cph on a footprint of only 1.90 x 2.65 meters, the new machine even surpasses the previous record-holder SIPLACE X4i in terms of performance per square meter.
Electronics Forum | Wed Jan 23 14:30:09 EST 2008 | operator
Additionally, I have seen the bad align error from incorrect pickup Z. Quad align can freak out sometimes if it sees something it doesn't like. If all else fails I just reboot and 99% of the time the problem goes away.
Electronics Forum | Wed Jan 23 13:02:35 EST 2008 | tbkonrad
Thanks for the info. I called Mike Tieman earlier and he recommended I do the exact same things. He said that there should be very little resistance on the theta of the Z-rods, (not the case) so he recommended that the P4 head be replaced. Mike is
Electronics Forum | Wed Jan 23 14:26:52 EST 2008 | operator
I have seen the bad alignment error many times and never had to replace the head for it. It usually has something to do with the laser windows being dirty or cracked. Also it could be your profile settings. Make sure all of these things are perfect b
Electronics Forum | Wed Jan 23 12:35:24 EST 2008 | bobpan
Here is a few things to try.... 1. Spin the z-shaft with your fingers and make sure it is smooth and easy to turn. 2. Check your handling in your profile for the part that the software is locking up on.......You cannot go any slower than 40% or this
Electronics Forum | Wed Jan 23 15:13:54 EST 2008 | tbkonrad
It's not the z pickup or profile bot thanks for the help, I think Mike is right. I have used these profiles hundreds if not thousands of times in the past and never had an issue. Also it was different components and different profiles almost every ti
Electronics Forum | Wed Jan 23 11:28:47 EST 2008 | tbkonrad
Help! Since last Friday i have been having issues with a Quad qsv-1, it all started with a quad align error, i found there to be a small quantity of grease covering the lenses on both quad align sensors. I wiped the grease off and then everything s
Electronics Forum | Wed Mar 05 14:03:12 EST 2014 | jhamlet
We have a Quad QSP-2 that recently started moving the gantries around incredibly fast and erratic at random times, but always while placing on a board. Any help would be appreciated. Thanks.
Electronics Forum | Wed Mar 19 17:18:24 EDT 2014 | aybars
I would suggest to check your servo amps. on both gantries and both axis.Does it rattle both heads or just one? Since you did not specify this in your question,I will say check all 4 servos in the back side of your machine.Hope this will help and goo
Electronics Forum | Thu Mar 06 17:27:17 EST 2014 | bobpan
Does this happen with just 1 gantry? If so...I would think your encoder in that gantry/axis needs cleaned. I have seen digital i/o cards cause this issue. But usually you will notice this when opening and closing the doors. The head would sometimes
.jpg)
