Electronics Forum | Thu Sep 05 21:31:36 EDT 2013 | nophsem
Hi: Our machine (QUAD 4C) has a CyberOptics laser 6604033; when initialize at HOME, z-rod descends and doesn't retracts, which makes me think that the laser is misaligned, here's a link to the video recording: http://www.youtube.com/watch?v=W9ma7Zsf
Electronics Forum | Mon Mar 14 08:35:27 EST 2005 | ???
no...its losing its position and it homes ok so the sensor is not the problem.....there is a mod code that sets the illumination level for the quad align....make sure that is at 200 or higher. You may want to change the qa card if you have another on
Electronics Forum | Sun Apr 12 08:49:12 EDT 2009 | mki
Hello, I bought used QUAD IVc MKII with transport in "as-is" condition, powered it up (without air and PCB on machine) and all axes (X, Y, Z AND T(heta)shows signs of life. Machine is performing HOME positioning self test. I am not familiar with QUA
Electronics Forum | Fri Sep 22 15:35:14 EDT 2006 | lheiss
Hello all, Finally ready to run my first 14 up array and the machine picks up the part moves to the placement location, them moves to home and drops the part. The Z axis never moves. I do get a "run error 1" at about the 4th placement (if it was a
Electronics Forum | Fri Aug 16 03:44:12 EDT 2013 | rollon65
Hi. Sorry I don't have an answer for this but I have the same problem in the "Y" axis on one of my 4Cs after the machine has run for around 4 hours. The machine seems to partially correct for the pick-ups being off as the placements are fairly good
Electronics Forum | Tue Sep 03 05:37:06 EDT 2013 | bobpan
It sounds like your dispenser has a problem....The default mod code for 56 is 0 (this should be off). Thats why when you cleared the mod codes the machine was able to home. When you reload your saved mod codes it is probably set to 1. The machine wil
Electronics Forum | Tue Jan 11 13:28:14 EST 2011 | jmw
0603 and up should be no problem on the machine. If you are doing under 25 mil pitch the machine needs an upward camera to repeatably place the parts. You will always lose the first 10 or so parts with cut tape but that should be about it. Repair par
Electronics Forum | Tue May 07 09:32:39 EDT 2013 | ngineer
Yesterday, my Quad IVc was on, but not running. There was a power fluctuation. I immediately got a motor err #5. I checked all the doors were closed, tried to home / reset the machine, and then turned it off and back on. Neither breaker was trip
Electronics Forum | Tue May 07 09:33:04 EDT 2013 | ngineer
Yesterday, my Quad IVc was on, but not running. There was a power fluctuation. I immediately got a motor err #5. I checked all the doors were closed, tried to home / reset the machine, and then turned it off and back on. Neither breaker was trip
Electronics Forum | Wed Aug 28 21:47:22 EDT 2013 | nophsem
HI! We have a QUAD 4C since 8 months . Yesterday the head remained immobile in the position where it put the last component to complete a board and indicates Motor Error # 5 (SRX engine communication time-out) and I don’t know what it means and ho