Electronics Forum | Mon Nov 24 16:29:10 EST 2014 | kevinb
I have a Quad QSV-1 machine. It has been off for over a year with no power to it at all. I found out that I lost the BIOS on the machine. I have two QSV-1 with the serial numbers one apart from the other so I copied the bios from one to the other
Electronics Forum | Wed Feb 11 09:29:59 EST 2015 | bobpan
A reading of 1 almost always means that there is something on the lens or possibly dust inside the unit blocking the laser and tricking the machine into thinking the nozzle is already down when it starts to step from the home 'up' position. Usually i
Electronics Forum | Tue Feb 09 10:01:08 EST 2021 | bobpan
1. The resistor is normally hot. 2. If the machine is crashing towards the front then the system settings need reset. Do this by pressing and releasing the e stop then pressing both front left buttons on the mylar below the lcd screen. Go into the ma
Electronics Forum | Fri Aug 30 05:34:28 EDT 2013 | bobpan
I would check the following: 1. Make sure the head can move in all axis including z and theta by physically moving each. 2. Check the voltage from the main power supply which is located in the middle of the machine on the top of the main board asse
Electronics Forum | Thu Nov 12 04:40:03 EST 1998 | Galen
| Scott - Good to see things are going well for you. With regard to your comments, Quad has introduced a complete line of Semi-conductor/APT machines (Q Series) that support both SMT and Semi-conductor applications. The machines were introduced in
Electronics Forum | Mon Nov 21 14:22:22 EST 2011 | mosborne1
Tim, The main controller card has a battery on it. Power down the machine and disconnect power. Stick a credit card between the battery and the clip. Hold for at least 60 seconds. Then power back up the machine. Make sure to have yourmod codes writ
Electronics Forum | Mon Jun 10 12:59:12 EDT 2013 | rollon65
Hi. Bobpan. Thanks for the reply. This CE machine does not have the side cover switches like my others do, but the good news is that I have now got the machine to initialize and home etc. I bought the machine "as seen" although I was told it was a
Electronics Forum | Mon Jul 22 14:06:16 EDT 2013 | bobpan
I dont have a machine to look at but its one of 2 ways.... 1. It finds a home sensor then counts out to a position. 2. It finds an etched mark on the glass scale then counts out to a position from there. I know the Q-series machines does the second
Electronics Forum | Fri Sep 06 05:09:13 EDT 2013 | bobpan
Mod code 69 in early firmware versions was laser align part size addition but in later versions is was laser intensity.....if its set to 0 try it at 250 and see what it does....if this doesnt work....set it back to 0. It seems that when you put somet
Electronics Forum | Thu Sep 08 15:22:32 EDT 2016 | bobpan
If its a tall part and you are trying to scan it lower than 200 or so...you can have this problem (limit error). Thinking of things to look at.....Is your z-rod spring sticking? Push up on it and it should spring back with NO hesitation...if it does.