Electronics Forum | Fri Oct 05 09:04:27 EDT 2018 | dleeper
Check with: http://www.goppm.com They are a good resource to have if you are supporting a Quad machine. Insert standard "I receive no benefit nor compensation from the aforementioned company"
Electronics Forum | Sat Feb 02 04:48:30 EST 2019 | dfl
yes it's moving at the wrong pitch, about 3 components a time. Is the programming you talking about at the microcontroller AT85C55 or that serial memory 24C04? Or there is some procedure on the Quad to adjust this?
Electronics Forum | Thu Oct 29 08:16:41 EDT 2009 | leemeyer
A Quad IV C would fit your application well. They are work horses. Repair parts are available but they just don't seem to breakdown often.
Electronics Forum | Tue Jan 11 16:38:18 EST 2011 | gosswald
JMW, Thank you for your reply. Can you add the upward camera to this machine that does not have it after purchase? If so what is involved? I do have typically two items per board that would be below 25 mil pitch.
Electronics Forum | Wed Jan 12 07:22:02 EST 2011 | jmw
To add the camera to the machine would have a lot involved......including possible software/firmware upgrade. I would say buy a machine that already has it on it. To find the parts and upgrade it would probably cost more than the machine is worth. Ho
Electronics Forum | Wed Jan 12 09:47:14 EST 2011 | gantry
Definitely agree with JMW, most machines you find will already have the upward looking camera unless it was the first (or second) head in a multi-head system. I would not look at a C-series without the upward looking camera
Electronics Forum | Tue Oct 09 06:14:48 EDT 2018 | bobpan
Move the camera over a feeder position and shine a flashlight to see if the image improves.....if it does....your light ring needs replaced or the led's need replaced in it. Sometimes just re-adjusting the angle of the led's in the ring can help. Go
Electronics Forum | Tue Oct 09 10:52:57 EDT 2018 | bobpan
re-adjust them .....yes just bend them in a little more. As for led's ....i have tried all kinds...some work better than others.
Electronics Forum | Tue Oct 09 13:15:27 EDT 2018 | dleeper
Bob Wasn't there a MOD code or Function code that controlled default light brightness? My memory is fuzzy on this so I might be completely off base.
Electronics Forum | Wed Oct 10 12:56:26 EDT 2018 | bobpan
ya.....i forgot about that........ mod code 35 and mod code 36 control lighting on the machine. Full brightness is 255. There are also light setting in the configuration file but i tend to keep people out of it. Thanks, Bob
