Electronics Forum | Sat Jan 26 15:47:10 EST 2019 | dfl
I'm with an annoying problem with an IV-c. Almost all the time the Y-axis "stuck" when the machine is homing. The motor tries to move the axis but only make a sound. If I move the axis by hand it can complete the homing and then goes to the IDLE. So
Electronics Forum | Fri Aug 02 19:45:58 EDT 2019 | bobpan
haha....thanks Steve!!! Nozzle Height of 1 means that you have dust or something in the quadalign lens. You need to clean the lens with alcohol then a dry lint free cloth and if it stays the same....that means the lens has an issue or there is dirt
Electronics Forum | Tue Jul 21 20:39:42 EDT 2020 | jmelson
Yes, but they really only seem to be interested in dealing in PPM-refurbished Quad IV C machines. They will sell parts but don't seem to be very interested in supporting other models under the Quad label. (The QSA-30 was made by Samsung, but uses Q
Electronics Forum | Fri Aug 02 12:03:16 EDT 2019 | dfl
UPDATE: I was reading around about similar problems. My function #30 always return nozzle height 1. I tried to clean up the glasses and the internal laser lenses, no go, still at height 1. Even after removing both glasses, still at height 1. I saw s
Electronics Forum | Sun Aug 04 08:47:12 EDT 2019 | dfl
Hey bob, I had no luck. Even removing both glasses, cleaning that curved lenses with a cotton swab and isopropanol and blowing compressed air, the height still on 1. I will try on the next weekend again, to be sure, but my first guess is the QA un
Electronics Forum | Wed Jan 30 15:08:10 EST 2019 | dfl
MM, exchange the cards doesn't make any difference. The problem happens when the machine is moving from left to right. Right to left works all the time. bobpan, thanks, I completely missed this one. The default was 0 and now is set to 1. The build c
Electronics Forum | Mon Jan 10 17:12:53 EST 2011 | gosswald
I have been researching older lower cost used Pick and Place machines and so far I am leaning towards the Quad IV C. There seems to be a fair amount of these units around and I have heard some pretty good things about them on some of the past posts.
Electronics Forum | Wed Apr 01 10:17:19 EST 1998 | Stefan Witte
| I have a customer looking to buy Quad 3C Feeders. | He is evaluting the possibility of either buying these | feeders or buying a whole Quad Pick and Place. | Qty: 30 8mm Feeders I do have a source of Quad III C and IV C machines with a total of 200
Electronics Forum | Tue Jan 11 13:28:14 EST 2011 | jmw
0603 and up should be no problem on the machine. If you are doing under 25 mil pitch the machine needs an upward camera to repeatably place the parts. You will always lose the first 10 or so parts with cut tape but that should be about it. Repair par
Electronics Forum | Fri Aug 02 08:12:55 EDT 2019 | dfl
Hey guys, I'm using my Quad IV-c for a while now and I already manage to run some batches, but I never used the "Quad Align" feature before, since almost all my boards are 1206 parts, that doesn´t need a ton of precision to align. Anyway,