Electronics Forum | Thu Jun 30 13:49:15 EDT 2011 | jholif
I am seeing a motor error 4 intermittently during operation. Sometimes it happens as soon as a program starts, sometimes it will perform 1-6 placements and then stop with it. I have swapped the stepper motor driver cards, the EPCU card, the SRX card
Electronics Forum | Sun Dec 04 15:42:21 EST 2011 | ngineer
Thanks for the reply bobpan. I had the motor power on. I did have a side panel that was not shut all the way. Once I shut that, the error went away and it made it through its startup sequence. No errors. Thanks for the help.
Electronics Forum | Sun Dec 04 10:40:23 EST 2011 | bobpan
Do you have the motor power turned on? It is next to the main power breaker (front panel of machine). Are all the covers down? Are the side covers pushed all the way in? What is the led status of your driver cards? They should be all green with no re
Electronics Forum | Sun Jun 07 11:47:10 EDT 2020 | saduquette
Hi, I went to run my IVC yesterday and it got a Motor Error on first pickup. Pressing Enter showed Z:-27:0 So according to the manual that means the Zaxis was commanded to go to -27, but the limit is '0'. I tried a Function 3 on that pickup and
Electronics Forum | Tue May 07 14:47:31 EDT 2013 | ngineer
Z axis seems to move as it should, the flag that goes through the C shaped sensor is not broken. I have gotten it to stay on everytime i start it up now (I did NOT change anything, just unplugged it for awhile, then plugged it back in an flipped the
Electronics Forum | Tue May 07 15:30:41 EDT 2013 | bobpan
your card is probably bad.....you can ohm out the motor and cable if you want... z motor windings 1.36 ohms z motor cable and windings 1.82 ohms good luck
Electronics Forum | Tue Nov 08 07:23:03 EST 2011 | leemeyer
Thanks Bobpan, A function 6 tells me that I have firmware ver IVC 3.05. I keep getting a motor error 4 "The Xand/or Y axis did not reach the commanded position within 500 msec." The battery was dead on this machine so the mod codes were lost. I en
Electronics Forum | Sun Dec 04 02:20:20 EST 2011 | ngineer
I just got my hands on a Quad IVc, and am trying to find information on a Z-axis Error # 5 @ startup. I haven't really done anything since recieving the machine, I powered on, the Transport moves back and forth, the pc boots and I press enter to log
Electronics Forum | Thu Dec 29 04:19:52 EST 2005 | lvqp72
We've run into a persistent QA error 99 on one of our Quad IVC's. Have checked upon all the obvious and found no bad components. Do appreciate any advice on this problem. Thanks.
Electronics Forum | Fri Aug 02 08:12:55 EDT 2019 | dfl
Hey guys, I'm using my Quad IV-c for a while now and I already manage to run some batches, but I never used the "Quad Align" feature before, since almost all my boards are 1206 parts, that doesn´t need a ton of precision to align. Anyway,
