Electronics Forum | Tue May 07 09:32:39 EDT 2013 | ngineer
Yesterday, my Quad IVc was on, but not running. There was a power fluctuation. I immediately got a motor err #5. I checked all the doors were closed, tried to home / reset the machine, and then turned it off and back on. Neither breaker was trip
Electronics Forum | Tue May 07 09:33:04 EDT 2013 | ngineer
Yesterday, my Quad IVc was on, but not running. There was a power fluctuation. I immediately got a motor err #5. I checked all the doors were closed, tried to home / reset the machine, and then turned it off and back on. Neither breaker was trip
Electronics Forum | Mon Apr 13 14:48:38 EDT 2009 | bobpan
There is also a modify code that if set to 0 the quad-align will not turn on and you will have this error. It is one of the higher mod codes around 60-80......been so long i forget.... Good Luck Bob
Electronics Forum | Wed Nov 06 13:27:55 EST 2013 | jeffl
Is there a schematic available online for this feeder or can anyone send me a schematic? I have an issue where the reverse does not work anymore. The switch (black button) is OK and the motor itself checks out OK. The problem is likely on the board i
Electronics Forum | Fri Mar 11 09:28:34 EST 2005 | Micheal
I need help on a Quad IVC. We are having intermitant problems. What happens is it runs and then all of a sudden the Z goes down into the feeder past the limit. I have changed the Z motor, cleared the memory, and also swapped motion controller boards
Electronics Forum | Tue Nov 08 15:07:51 EST 2011 | gosswald
I have been in the process of setting up a Quad 2C that lost its mod codes myself. Have you cleaned the glass encoder strips for X and Y? I was getting alot of motor errors until I cleaned them and I believe it was the error 4. Hope this helps.
Electronics Forum | Sat Jan 26 15:47:10 EST 2019 | dfl
I'm with an annoying problem with an IV-c. Almost all the time the Y-axis "stuck" when the machine is homing. The motor tries to move the axis but only make a sound. If I move the axis by hand it can complete the homing and then goes to the IDLE. So
Electronics Forum | Thu Sep 26 10:04:46 EDT 2013 | nophsem
I tested original 'bad' SRX card in the other machine and it doesn't work, same error: SRX Autobaud Motor error #5 With our QUAD 4C, (Machine speed setting) MC 53= 0 (high speed), I changed =1 (low speed), same error
Electronics Forum | Tue May 07 16:02:09 EDT 2013 | ngineer
That's good info for making sure the motor is good before plugging in and possibly over-current another stepper drive. Do you happen to have pin-outs for the DB15 on the drive board, pot settings and current limit of this drive? We keep several ste
Electronics Forum | Sun Jan 27 17:59:25 EST 2019 | bobpan
The y-axis on that machine is left to right. If this is the axis you are having a problem with....check the motor. I have had to tighten the tension on it before. If you notice you lose steps after running for a while then this is going to be the iss
