Electronics Forum | Sun Jun 07 11:47:10 EDT 2020 | saduquette
Hi, I went to run my IVC yesterday and it got a Motor Error on first pickup. Pressing Enter showed Z:-27:0 So according to the manual that means the Zaxis was commanded to go to -27, but the limit is '0'. I tried a Function 3 on that pickup and
Electronics Forum | Thu Nov 18 10:48:42 EST 1999 | Roger Scalia
With the low volume and low parts mix Quad 100's, Quad IIIC"s or Quad IVC's would be a low cost method of placement. As for ovens most any 5 to 7 zone oven will work for you. Thanks,
Electronics Forum | Fri Jan 25 08:54:33 EST 2019 | dfl
For the first time, I'm really looking at to the power transformer for the IV-C pick and place (the big big one, at the middle). As I understood, is this transformer converting the 220V to 127V? I realize that the camera monitor is 127V and the PC PS
Electronics Forum | Tue Dec 19 11:40:47 EST 2023 | jeana
Hello everyone, We recently got a Quad IVc machine with PPM software on it. We are struggling with 0402, as we get plenty QuadAlign failures. We ticked Vision on failure, so that we limit the amount of rejected parts, but on 0402 Vision system gi
Electronics Forum | Tue May 17 06:05:13 EDT 2011 | bobpan
The camera's are different. I think you can get them repaired but you should be able to find used/new ones. Try PPM as a supplier of old quad parts. Good luck
Electronics Forum | Mon Jan 27 10:06:03 EST 2003 | binns
Just to set the record straight... Samsung did not build all Quad machines. QSA = Quad Samsung America, The QSA-30 machine platforms were manufactured by Samsung, utilizing Quad feeders, other Quad technology and Quad sales and service. Before the
Electronics Forum | Mon Apr 01 15:45:05 EDT 2013 | leemeyer
In order to create a new part you must first select one of the parts that is installed with autoprogram. The edit button will become active so that you can create a part.
Electronics Forum | Fri Mar 11 11:19:02 EST 2005 | Steve C.
I would change the Quad Align cable. If you have a spare head board swap that out as well. Make sure your Quad Align lenses are clean. If the camera is smudged then you can have some problems aligning parts as well. Let us know what you find. Cheers.
Electronics Forum | Thu May 05 07:41:19 EDT 2011 | leemeyer
Yes, what you are thinking is correct. Assuming an 0805 capacitor parts that are picked from the front and back of the machine will be picked at 0 theta. Parts that are on the left or right will be picked at a 90 theta. This way they can all share th
Electronics Forum | Thu Aug 16 14:29:00 EDT 2012 | bobpan
Sounds to me like a dirty quad-align. If you have cleaned the lens and have the same results then you may have dirt on the inside of the quad-align. The only fix is to replace it or blow it out with an air gun. Unfortunately it is not easy to tell if
winsouce.jpg)
