Electronics Forum | Thu May 05 11:11:20 EDT 2011 | jimlas53
OK, understood. In the case of SO14, I have some in vibe feeders and some in tape. The tape parts, when I set the extent up, would be picked at 0 Theta, because the part length is parallel to the Y axis. The vibe parts, which are perpendicular to
Electronics Forum | Wed May 04 21:32:30 EDT 2011 | jimlas53
Thanks for the answer, RLM, I couldn't find anything in the manual that was helpful. If I use a common extent for each component type, I need to identify those components that may be turned due to the feed type (tape, vibe). Is this where I would d
Electronics Forum | Fri Apr 05 14:17:11 EDT 2013 | leemeyer
I have no idea why this limitation would be programmed in. Like I said before there a lot of wierd quirks whith this software and you may have just found one. Pre-assigning will not help if the software sees a mismatch between the feeder plate and th
Electronics Forum | Thu Aug 16 07:40:27 EDT 2012 | bobpan
Here are a couple of things to look at. 1. Watch the machine run....and if it misses a part....make sure it doesnt blow out the next part being presented. Sometimes the air pressure is too high and the vacuum verify will blow the part out of the poc
Electronics Forum | Wed Dec 20 13:45:08 EST 2023 | bobpan
I dont know what kind of feeders your using for 0402 but it matters. It must be repeatable. It also sounds like your feeder z height is wrong. Test pick on the feeder and change the z until it just starts to pick it up and your z will be set. One oth
Electronics Forum | Wed May 01 15:27:22 EDT 2013 | lheiss
Hi All, I've been using a IVc for many years. I'm to the point where I have Mod Code 8 = 15, MC9 = 500, and all Extents PU delays set to 40ish. These settings work pretty well but I would like to get them closer to factory defaults to save the los
Electronics Forum | Thu Jan 16 18:14:35 EST 2003 | jonfox
You can still get support. I was in that deal before Tyco decided they didn't need Multitronics field engineers playing with Quads. Anyway, most of the original Quad personnel are stil running service. Based by region, in the West or Central US, c
Electronics Forum | Fri Aug 02 08:12:55 EDT 2019 | dfl
Hey guys, I'm using my Quad IV-c for a while now and I already manage to run some batches, but I never used the "Quad Align" feature before, since almost all my boards are 1206 parts, that doesn´t need a ton of precision to align. Anyway,
Electronics Forum | Tue Oct 10 15:14:43 EDT 2006 | mfoster
Hi Phil, Most parts are still available for the Quad/Samsung QSA-30, through Dynatech (in North America). It is actually a single gantry, 3 spindle machine with rated speed of 14,000 cph. As with any used machine, it could be a great deal or a not
Electronics Forum | Tue May 03 17:59:19 EDT 2011 | jimlas53
As I continue to add more components/feeders to our assembler, I add a new laser align extent for every pick. But if components are standardized (like 0805, SOT-23) is it necessary to have all individual extents or just an extent for each type? Thi