Electronics Forum | Wed Sep 12 06:13:22 EDT 2012 | bobpan
Glad i could help.....now this is a little harder....been a long time since i have done comp. fids and i dont have a machine to test....but check these things... 1. In the teach menu.....there is teach component fiducials. Make sure you do this with
Electronics Forum | Thu Aug 16 12:46:47 EDT 2012 | derekj
Thank you for your reply Bob. 1. It appears the machine is picking the part up, hovering over the board and rejecting it. So it's not blowing the parts out of the pocket. Turning the vv off still results in the same issue. 2. All the tolerances are
Electronics Forum | Fri Apr 05 13:53:56 EDT 2013 | microaide
0.700. What is special about 0.700? My part is an SOLIC14, which has a length of 0.350. So 0.700 is exactly twice the length of the part. Is there a problem feeding a part from a vibratory feeder if the escapement length is more that twice the lengt
Electronics Forum | Tue Apr 23 12:17:28 EDT 2002 | binns
I have a couple of questions for you, and a couple of answers. 1. Which model ? (100, IIc, IVc, QSV, QSP ) 2. In reference to how the machine stacks up with Fuji and Panasonic. They have never stacked up. Those families of machines have historicall
Electronics Forum | Tue Nov 10 09:45:52 EST 1998 | Scott McKee
| We are currently in the process of purchasing a new low volume SMT line. Based on our research, Quad and Mydata seems to best fit our applications. Has anyone used both equipment and experience the pro and cons of each machine? Thanks in advance fo
Electronics Forum | Tue Aug 22 13:13:30 EDT 2006 | slthomas
We are a low volume (100k-150k parts per month) high mix shop that is equipped with a couple of Quad IVc's. The machines meet our overall capacity needs but can not give us the quick turns we need if we get hit with multiple large setups at once.
Electronics Forum | Sat Mar 09 02:25:35 EST 2013 | ngineer
I'm setting up a rather complicated job on our quad IVc. I was almost done (after days), and after i did the sequence, i saved it, downloaded it, and started checking the picks and places, well, i needed to change one, and went back to the sequence,
Electronics Forum | Tue Oct 27 20:41:07 EST 1998 | Scott McKee
| Does anyone have info on any of these systems (good or bad). We are looking at these 3 types for a new SMT pnp machine. We are low volume high mix. | | Thanks, Dave | I've worked with QuadIVc at Interstate... I then purchased a Mydata at this
Electronics Forum | Wed Oct 24 11:06:08 EDT 2007 | slthomas
While many here would probably shoot themselves at the thought, I'd recommend a Quad IVc. You can't get much smaller, they're easy to set up, easy to operate, and for the most part run pretty much forever with minimal maintenance because they're so m
Electronics Forum | Fri Apr 05 07:17:55 EDT 2013 | leemeyer
I've never seen one but i've been told that there is a 2 tier vib plate where the top plate is set back a bit so that the nozzle can pick from the top and bottom plate. OK so you have the plates on the machine and have entered their coordinates. Cl
