Industry News | 2018-05-07 20:58:38.0
Pickering Interfaces will showcase their broad catalog of PXI and Ethernet LXI RF & Microwave switching solutions at IEEE MTT-S 2018 International Microwave Symposium (IMS) at booth 2015 on June 10 – 15, 2018.
Industry News | 2013-06-18 23:01:40.0
Today ADLINK Technology announced availability of its initial offerings on the 4th generation Intel® Core™ processor family (formerly codenamed "Haswell") with Intel® 8-series chipsets.
Industry News | 2014-03-20 10:03:43.0
ADLINK Technology announced an array of new products in various form factors based on the latest Intel® Atom™ and Celeron® processors for intelligent systems, featuring a significant performance per watt improvement over previous generations, high integration of both low speed and high speed IO’s, an advanced graphics engine, and virtualization support - all on a sub-10-watt system-on-chip (SoC) that enables small, light, and reliable embedded designs.
Industry News | 2024-02-26 14:00:02.0
High-performance memory supplier chooses Saki's 3Si solder-paste inspection and 3Di inline AOI systems to handle miniaturization challenges and prepare for smart manufacturing.
Industry News | 2014-01-20 12:10:43.0
ADLINK Technology Inc., a leading supplier of Application Ready intelligent Platforms and industrial building blocks, will present amongst other products the following new highlights at the Embedded World Show Nuremberg at booth 1/1-538.
Electronics Forum | Wed Mar 25 18:29:47 EDT 2009 | badnewz
My Quad IVc's will also do the same thing. Mine are equipped with CyberOptics scanners, not QuadAlign. The Cyberoptics scanners do go bad and once they do, they get very warm to the touch and at the same time, if the Quad is reset, the theta axis wil
Electronics Forum | Thu Nov 18 10:48:42 EST 1999 | Roger Scalia
With the low volume and low parts mix Quad 100's, Quad IIIC"s or Quad IVC's would be a low cost method of placement. As for ovens most any 5 to 7 zone oven will work for you. Thanks,
Electronics Forum | Mon Mar 16 06:12:32 EDT 2015 | bobpan
The first thing to do is to change the z-rod. Sometimes a very old z-rod spring will weaken causing it to reject many parts. If it only rejects parts after a nozzle change....you may need to put some super lube grease on the O-rings on the bottom of
Electronics Forum | Fri Mar 13 15:09:20 EDT 2015 | marcelorotofrance
Hello everybody Lately our machine has been working pretty well, but it can’t last too long. Now, during this week’s production cycle, it began to increase the component’s reject rate to alarming levels (obviously the operators reported me when the m
Electronics Forum | Mon Jan 28 07:37:23 EST 2019 | babe7362000
You could also try swapping the motion cards. X and Y are swappable I believe. And see if the problem goes to the X. I have had to do that in the past for troubleshooting. It has been awhile since I have touched a IVC, but I loved those machines.