Electronics Forum | Mon Feb 04 08:04:39 EST 2013 | marcelorotofrance
Function 30 reads CENTER 1024 RUN OUT 0.0 with any nozzle and without nozzle at all. However I see that nozzle tip stops in front of laser beam. When I interrupt the beam with a piece of paper during Function 30, Z axis travels down until I take it
Electronics Forum | Tue Feb 05 19:00:18 EST 2013 | marcelorotofrance
I found problem, it was a faulty connector on the align processor card. So, Mr. Bobpan, I thank you very much for your invaluable guidance. P.S. My employer has been very clever and have purchased a 18 years old/ 25000 run hours/ third-hand equipmen
Electronics Forum | Mon Feb 04 11:01:44 EST 2013 | bobpan
The way its supposed to work...is....when you do a function 30 the z axis should step down until the nozzle tip is seen in the quad align or laser align. The readout should have a nozzle height but if its the earlier firmware for the machine it might
Electronics Forum | Thu Mar 26 10:42:16 EDT 2015 | bobpan
Glad that I can help.... Bob
Electronics Forum | Wed Jun 05 05:10:10 EDT 2013 | rollon65
Hi all. I already have a pair of Quad 4C Mk2 and purchased a Quad 4C Mk2 CE model secondhand. Some of the machine powers up but not the motor PCBs so the start up sequence stops after the nozzle changer operates with Motor Error #5 on the handheld.
Electronics Forum | Fri Dec 03 20:40:38 EST 2010 | olddog
We are a small company looking to purchase a used Quad 4c to bring some of our PCB fab in-house. In looking around at equipment we see both 4c and 4c mk2 versions of the Quad machine. Can someone please advise the difference between the two? Thank yo
Electronics Forum | Fri Oct 16 09:48:24 EDT 1998 | Jim Lewis
Help required on vision verify on Quad 4C/Mk2. In component editor, vision verify is OK. When linked into program, the following message occurs: "Bad or missing component description" Machine locks up. Can we get around this? If so how?
Electronics Forum | Thu Dec 24 14:52:24 EST 2020 | bobpan
Good job, For the comm errors i would try: 1. Reseat all the cables that plug into the white multiplexer that is attached to the back of the computer. 2. Reseat the EPCU card down inside the machine. good luck, Merry Xmas, Bob
Electronics Forum | Wed Dec 23 20:06:26 EST 2020 | marcelorotofrance
Hi, I'm using a "ye olde" Quad 4c Mk2 built in 1995 for eight years. During that period I had to change 3 HDD (now it runs a compact flash with and free DOS), 3 Z-rod bellows,3 laser heads, some monitors, nozzles and misc parts. Despite that it has t
Electronics Forum | Tue Oct 01 11:56:57 EDT 2013 | bobpan
I would try the following: 1. Back up your mod codes or make sure they are up to date. 2. Turn off the machine and slide a business card between the battery and the clip located on the EPCU card in the front card rack. 3. Download back in your mod co