Industry News | 2019-01-22 13:06:44.0
At IPC Apex 2019, PACE Worldwide will showcase their new TF Series of BGA Rework Systems. The TF1800 is designed for standard board sizes of up to 12” x 12”, while the TF2800 is for extra large, high mass PCB’s up to 24” x 24”. The TF1800 will be on display at our booth (#2809) and will be available for live demonstrations.
Industry News | 2019-01-22 16:00:09.0
At IPC Apex 2019, PACE Worldwide will showcase their new TF Series of BGA Rework Systems. The TF1800 is designed for standard board sizes of up to 12” x 12”, while the TF2800 is for extra large, high mass PCB’s up to 24” x 24”.
AAMA3535 ANALOG ALARM DIN RAIL MODULE AAMR6436 APOLLO ACCESSORIES ACA10000 ACE10000 ACE20000 ACE30000 ACE40000 ADI INTELLIGENT MESSAGE DISPLAYS ADI2R11A ADI2R11D ADI4T11A ADI4T11D ADI4Y11A ADI4Y11D SIGNAL CONDITIONING DIN RAIL MODULES
Electronics Forum | Wed Nov 27 09:51:08 EST 2002 | Claude_Couture
I have worked with 4c's for two years. The feeders are "tinker toys" with a mechanism that slips, so the pick-up has to be adjusted several times as the reel is used, especially with 13" reels. The worm gear was plastic on the steel shaft of the moto
Electronics Forum | Tue Apr 26 07:37:59 EDT 2011 | leemeyer
Have you performed the camera to nozzle calibration ? I can send you instructions for this if you need them.
Electronics Forum | Tue Apr 26 09:46:27 EDT 2011 | veeckm
Thanks for the reply. I have not performed the camera to nozzle calibration. Is this the same as the calibration of the vu3 camera in the manual? If you would please give me your instructions, any help is appreciated.
Electronics Forum | Tue Apr 26 10:14:06 EDT 2011 | leemeyer
The camera to nozzle offset calibration requires that you modify some of the mod codes once the offsets are calculated. This is not part of the VU3 calibration. Send me your email address so that i can attach a copy of the manual for you.
Electronics Forum | Mon May 09 16:32:05 EDT 2011 | veeckm
I got the camera nozzle offset corrected but after the machine runs for a while the offset will drift and its out the specs I set it to. Any help is appreciated.
Electronics Forum | Tue May 10 07:57:49 EDT 2011 | mosborne1
Are you uploading the mod codes to your central controller when you change them? If not when you run your produciton the central controller will download the mod codes that are stored in the CC. You might also have an encoder problem. When the machin
Electronics Forum | Mon May 16 06:02:14 EDT 2011 | bobpan
Multiple times i have seen where the downward camera lens inside of the camera becomes detached inside. It is just glued down. To see if this is the problem. Park the head over a spot and tap on the camera every direction. The crosshairs should NOT m